Garden Treasures 13-MZ12255GA Manuale - Pagina 6

Sfoglia online o scarica il pdf Manuale per Fontana da esterno Garden Treasures 13-MZ12255GA. Garden Treasures 13-MZ12255GA 15. 3 tier rust fountain

CARE AND MAINTENANCE

 Check regularly that the water reservoir has sufficient water to cover the pump at all times. It

will be necessary to check more frequently in warm or windy weather.

 Do not allow the pump to freeze. During cold spells, remove the pump from the water feature

and place in a water-filled container in a frost-free position. DO NOT store the pump dry.

 Periodically it will be necessary to change the water and clean the water feature and reservoir.

The frequency of this will depend on the weather and location of the water feature. The outside

of the water feature can be cleaned using a soft cloth and clean water and the reservoir with a

soft brush. A mild detergent can be used, but please note this will cause the water to foam and

should be avoided unless strictly necessary.

 The pump rotor will require cleaning at approximately monthly intervals. A good indication will

be if the water flow rate drops. Switch off and unplug the water feature, remove the pump from

the water reservoir and disconnect the water pipe. Remove the filtering cover and

pressure-casing from the front of pump body. Clean the rotor and housing in clean water using

cotton buds. Reassemble the pump, reconnect the water pipe and reassemble the water

feature.

PROBLEM

1. Pump is not covered with

water.

2. Pump or fountain is blocked. 2. Disconnect fountain from power source,

Fountain is

3. Pump is not secured

not

correctly.

pumping

water.

4. Pump is not electrically

connected.

5. Pump may be "air locked."

POSSIBLE CAUSE

CORRECTIVE ACTION

1. Add more water to the reservoir.

remove any obstruction, and clean bowl and

tubing.

3. Disconnect fountain from power source, pour

out any remaining water, and ensure the

tubing in the reservoir is tightly secured to

the pump outlet.

4. Check to make sure pump is plugged in and

the outlet is working.

5. Plug and unplug the pump several times to

clear any air that may have been trapped.