Jandy Jandy Pro Series Manuale - Pagina 2

Sfoglia online o scarica il pdf Manuale per Controllore Jandy Jandy Pro Series. Jandy Jandy Pro Series 8. Single element cartridge pool & spa cs filters
Anche per Jandy Jandy Pro Series: Manuale d'uso (12 pagine), Manuale di installazione (16 pagine), Manuale di installazione e funzionamento (20 pagine), Manuale d'uso (20 pagine), Manuale di avvio rapido (2 pagine), Manuale di installazione e funzionamento (20 pagine), Istruzioni per l'installazione (2 pagine), Manuale di installazione e funzionamento (16 pagine), Manuale di installazione e funzionamento (16 pagine), Manuale di installazione e funzionamento (16 pagine)

Stampa la pagina

Page 2

3. Installing Power Pack R-Kits

WARNING

Disconnect power to the system at the main circuit

breaker before performing this procedure to avoid

risk of electric shock which can result in property

damage, severe injury or death.

Control PCB Assembly

(R512300)

Power PCB

Assembly

(R512100)

Output Cable Assembly

(R512500)

Figure 1.

Power Pack R-Kits

A. Replacing the Power Pack Cover

Assembly, and the Control PCB

Assembly

Disassemble to the component that needs replacement.

1. Ensure that all power to the power pack and the

controller is disconnected/turned off at the circuit

breaker.

2. Detach the outer dress cover from the power pack

by pressing on each of the sides and lifting up

(see Figure 2).

Figure 2.

Power Pack Installed

Jandy

Pro Series AquaPure

Power Pack Cover Assembly

(R0512400)

Outer Dress Cover

To remove the outer

dress cover, press on the

sides and lift up.

Ei™ Series

Replacement Kit Instructions

3. Remove the screws attaching the cover to the back

plate and prop the cover up to expose the terminals.

Unplug the ribbon cable from the Power PCB

(see Figure 3).

Power PCB

Figure 3.

Unplug Ribbon Cable

4. Remove the power pack cover from the back plate.

Turn the cover over and remove the four (4) screws

attaching the Control PCB to the cover.

5. Attach the new Control PCB to the cover using the

four PCB mounting screws provided in the kit

(see Figure 4).

Figure 4.

Control PCB Installed

6. Plug the ribbon cable into the Power PCB.

7. Reattach the cover to the back plate using the four

(4) mounting screws.

8. Reattach the outer dress cover.

9. Reconnect the power.

Unplug the

Ribbon

Cable