KitchenAid KHLU162MSS0 Istruzioni per l'installazione e manuale d'uso e manutenzione - Pagina 5
Sfoglia online o scarica il pdf Istruzioni per l'installazione e manuale d'uso e manutenzione per Cappa di ventilazione KitchenAid KHLU162MSS0. KitchenAid KHLU162MSS0 20. 36" (91.4 cm) and 48" (121.9 cm) hood liner
Anche per KitchenAid KHLU162MSS0: Manuale delle parti (2 pagine)
Stampa la pagina
black
green
green
wire
ground
ground
(from
white
screw
wires
blower)
wires
twist-on
connector
black
wires
power
hood liner
supply
wiring
cable
Connect both green ground wires
(from exterior blower motor and
from 120-volt supply wiring)
under the unused green ground
screw.
120-volt supply wiring:
• Connect 120-volt black supply
wire to black hood liner wire with a
twist-on connector.
• Connect 120-volt supply white
wire with to white hood liner
wire with a twist-on connector.
Exterior blower motor wiring:
• Connect the black blower motor
wire to the blue hood liner wire
with a twist-on connector.
• Connect white blower motor
wire to brown hood liner wire
with a twist-on connector.
13.
Tighten strain relief screws.
14.
Replace wiring box cover.
Tighten screw securely.
15.
Connect exterior blower
vent system to hood liner collar.
Seal joint with duct tape to make
airtight.
16.
Reconnect power.
white
wire
(from
blower)
light
switch
brown wire
17.
(from hood
liner)
Check operation of hood
liner and exterior blower.
blue wire
(from hood
liner)
Lights:
• Move the light switch to "1"
exterior
blower
position. Lights should go on.
wiring
Move switch back to "0"
position. Lights should go off.
Exterior blower motor and speed
control:
• Move motor switch to "1"
position. Exterior blower motor
should turn on.
• Move speed control switch to
vary the blower speed from low
(at the left) to high (at the right).
• Move speed control switch back
to low (at the left). Move the
motor switch back to "0"and the
blower motor should turn off.
18.
Reinstall filters. Place back
edge of filter into channel at rear of
hood liner. Push filter up while
pushing tab back. When filter is in
place, release tab. Locking pin will
hold filter in place. Repeat with
other filter(s).
19.
Install front enclosure.
To get the most efficient use from
your new hood liner, read the
"Use and Care Information"
section. Keep your KitchenAid
Installation Instructions and Use
and Care Guide close to hood
liner for easy reference.
blower speed
switch
blower motor
switch
5