Using a 5-Slot Carrier
IMPORTANT: The 5-slot carrier and the processor module must already be mounted on the wall. If it is not, refer to
the documentation that came with your system.
5-Slot Carrier
1
A) Move the carrier's On/Off switch to "Off,"
and unplug the power cord from the wall
outlet.
B) To remove the cover on Release 3.0 or
earlier systems, loosen the screw on the
lower front of the cover.
C) Place one hand on the handle on the
bottom front of the cover, and place your
other hand on the top of the cover. Gently
pull the cover up and away from the carrier.
PFT
L
I
N
E
S
PFT
E
X
T
E
N
S
I
O
N
S
A) Verify that the processor module is in the
4
center slot of the carrier. In the other slots,
from left to right, install modules in this order:
1600 DSL, 308EC(s), 012E, 206(s), then
400(s) or 200(s).
NOTE: If you intend to use the FAX CNG
Detection feature (with ACS), for optimal
performance, insert the 308EC R3.0
module to the left of any 308EC module
prior to R3.0.
B) Align the module carefully in the
appropriate slot. On a Release 4 carrier, lift
the plastic latch on the top of the carrier.
Push slowly but firmly in the center of the
module until the connectors on the module
lock into place and the module is attached to
the rear of the carrier. On a Release 4
carrier, check that the plastic latch on top of
the carrier is secured in the rounded slot on
top of the module (See CAUTION on the last
page.)
!
CAUTION:
Do not force the module. If the module
does not insert easily, remove it, clear
any obstruction, and reinsert it.
On/Off Switch
Power
Jack
2
If you are removing an existing module, see if
there is enough slack to remove the module
without pulling the line and extension cords
free. If necessary, label and disconnect the
cords. Then, grab the center of the module
with one hand. With the other hand, push up
on the plastic tab at the top of the slot on the
carrier and pull out the old module.
5
A) Label the line and extension jacks.
B) Connect the line and telephone cords to
the appropriate jacks on the new module.
C) Route each cord through the hook on the
front of its module.
D) Connect the free end of each line cord to
the appropriate network interface jack.
E) Connect the free end of each telephone
cord to the modular connecting blocks for
system extensions.
F) Gather the line and extension cords
hanging below the hook and twist tie or wire
wrap them.
G) Place the bundle of wires in the
indentation on the bottom of the carrier.
3
Before installing any modules, remove the
clear, plastic protector from the connector on
the rear side of the module by grasping the
tabs and lifting.
5-Slot Carrier
6
A) Plug the power cord into a properly
grounded three-prong wall outlet not
controlled by a switch.
B) Power up the control unit by moving the
On/Off switch to the "On" position.
Lights
20
1
21
2
22
3
7
Check the green lights on the fronts of the
modules:
A) If a single light is out, power down the
carrier, reseat the module, and then power
up the carrier.
B) If multiple green lights are out, power
down the carrier, reseat the leftmost module
that has a light out, and then power up the
carrier.
C) If the lights are still out, see the Customer
Support Document on the accompanying
compact disc for information about whom
you should contact.
Tab
Tab
On/Off Switch
Power
Jack
23
26
24
27
25
28
Stampa la pagina