KitchenAid KEMS309BSP Manuale di istruzioni per l'installazione - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Forno a microonde KitchenAid KEMS309BSP. KitchenAid KEMS309BSP 16. 27" (68.6 cm) and 30" (76.2 cm) electric built-in microwave/oven combination

Stampa la pagina

3. Push oven completely into cabinet and center oven into

cabinet cutout.

NOTE: If you have model KEMS379B, KEMS309B or

KEHU309B, proceed to Step 5.

4. Insert the grommet into the mounting rail hole using a flat-

blade screwdriver. Insert the screwdriver into the grommet

and turn ¹⁄₄ turn counterclockwise. Make sure the grommet

stays in position.

IMPORTANT: If the grommet is not installed, the front frame

will be damaged.

A. Mounting rail

B. Mounting rail hole

C. Grommet

5. Securely fasten oven to cabinet using the #8–14 x 1" screws

provided. Insert the screws through hole in the grommet. Do

not overtighten screws.

6. On some models, the oven vent is recessed inside the

packaging. See the following instructions to install.

Insert the vent tabs (B) into slots (A) in the oven frame.

With one #8–18 x ³⁄₈" screw (C) for each side of the vent,

fasten vent securely to the oven.

A. Oven frame slot

B. Vent tab

C. #8–18 x ³⁄₈" screw

D. Oven vent

7. Replace oven racks.

8. Replace oven door by inserting ends of hinges into hinge

slots in the oven frame.

9. Push hinges in as far as they will go and open the oven door.

You should feel the oven door drop into place.

10. Rotate both hinge latches back to the locked position.

11. Check that door is free to open and close. If it is not, repeat

the removal and installation procedures. See "Prepare Built-In

Microwave/Oven Combination" section.

12. Reconnect power.

13. Display panel will light briefly, and "PF" should appear in the

display.

14. If display panel does not light, please reference the

"Assistance or Service" section of the Use and Care Guide or

contact the dealer from whom you purchased your oven.

Install Warming Drawer Deflector Kit (only

for ovens installed above warming

drawers)

On combo microwave/oven models installed above a warming

drawer, a warming drawer deflector kit must be installed. See the

"Tools and Parts" section for ordering information.

Parts Supplied

A. Phillips head screws (4)

only 2 screws for 27" (68.6 cm) size

B. Warming drawer deflector (1)

Install Deflector Kit

1. Align the deflector (B) with the vent (C) as shown.

2. Using two #8-18 x ¼" screws (A) on each side of the deflector

(B), fasten the deflector securely to the vent.

NOTE: On 27" (68.6 cm) models, only one #8–18 x ¼" screw

is used on each side.

A. #8–18 x

B. Warming drawer deflector

C. Vent

3. Align vent tab (B) with oven frame (A) as shown.

¹⁄₄

" screws