Lexmark MS610 Series Manuale di trasloco

Sfoglia online o scarica il pdf Manuale di trasloco per Stampante Lexmark MS610 Series. Lexmark MS610 Series 2. Machine type 4514-630, 4514-635, 4514-636
Anche per Lexmark MS610 Series: Nota tecnica (3 pagine), Manuale (20 pagine), Manuale di connessione (6 pagine), Manuale di stampa (5 pagine), Riferimento rapido (18 pagine), Paper Manual (4 pagine), Manuale informativo (1 pagine), Scheda di configurazione (2 pagine), Specificazioni (2 pagine), Manuale di servizio (18 pagine), Riferimento rapido (17 pagine)

Stampa la pagina
Lexmark MS610 Series Manuale di trasloco
Moving Guide

Before moving the printer

CAUTION—POTENTIAL INJURY: Before moving the printer, follow these guidelines to avoid personal injury or printer
damage:
•
Turn the printer off using the power switch, and then unplug the power cord from the electrical outlet.
•
Disconnect all cords and cables from the printer before moving it.
•
If an optional tray is installed, then remove it from the printer. To remove the optional tray, slide the latch on the right side
of the tray toward the front of the tray until it clicks into place.
•
Use the handholds located on both sides of the printer to lift it.
•
Make sure your fingers are not under the printer when you set it down.
•
Before setting up the printer, make sure there is adequate clearance around it.
Use only the power cord provided with this product or the manufacturer's authorized replacement.
Warning—Potential Damage: Damage to the printer caused by improper moving is not covered by the printer warranty.

Selecting a location for the printer

When selecting a location for the printer, leave enough room to open trays, covers, and doors. If you plan to install any hardware
options, then leave enough room for them also. It is important to:
•
Set up the printer near a properly grounded and easily accessible electrical outlet.
•
Make sure airflow in the room meets the latest revision of the ASHRAE 62 standard or the CEN Technical Committee 156
standard.
•
Provide a flat, sturdy, and stable surface.
•
Keep the printer:
–
Clean, dry, and free of dust.
–
Away from stray staples and paper clips.
–
Away from the direct airflow of air conditioners, heaters, or ventilators.
–
Free from direct sunlight and humidity extremes.
•
Observe the recommended temperatures and avoid fluctuations.
Moving Guide
Page 1 of 2