Makita 6011DW Manuale di istruzioni - Pagina 6
Sfoglia online o scarica il pdf Manuale di istruzioni per Trapano Makita 6011DW. Makita 6011DW 13. Equipped with keyless chuck and electric brake
Stampa la pagina
Installing or removing
battery
cartridge
*Always switch off the tool before insertion or removal
of
the battery cartridge.
*To remove the battery cartridge, pull out
the set plate on the tool and grasp both
sides of the cartridge while withdrawing
it
from the tool.
*To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip it into
place. Snap the set plate back into place.
Be sure to close the set plate fully before
using the tool.
I
Set plete
Do not use force when inserting the battery cartridge.
If the cartridge does not slide in easily,
it
is not being inserted correctly.
Charging
Plug the fast charger into your power
source. Insert the battery cartridge so that
the plus and minus terminals on the bat-
tery cartridge are on the same sides as their
respective markings on the fast charger.
Insert the cartridge fully into the port so
t h a t it
rests on the charger port floor.
Press the start button (red). The charging
light will come on and charging will begin.
If the charging light does not come on,
press the reset button (yellow) first, then
the start button (red). If the charging light
goes out within 10 seconds even after pressing the reset button and start button a couple
of times, the battery cartridge i s dead. (CAUTION: Wait for more than 5 seconds after
the charging light goes out to press the reset button again.) Replace it with a new one.
When the charging light goes out after about one hour, you may remove the fully charged
battery cartridge.
After charging, unplug the charger from the power source.
CAUTION :
Your new battery cartridge i s not charged. You will need to charge
it
before use.
Do not keep the button pressed in with tape, etc. or the circuit will not function pro-
perly. Also,
a
malfunction of the charger may result possibly causing overheating, etc.
0
If you try to charge a cartridge from
a
just-operated tool, sometimes the charging light
will not come on. If this occurs, l e t the cartridge cool off for a while. Then reinsert it
and try to charge
it
once more.
When you charge a new battery cartridge or
a
battery cartridge which has not been used
for
a
long period, it may not accept a full charge. This i s
a
normal condition and does
not indicate
a
problem. You can recharge the battery cartridge fully after discharging
it
almost completely
a
couple or times.
If you wish to charge two battery cartridges, allow 15 minutes between chargings on the
fast charger.
6
..