Makita 6216DWAE Manuale di istruzioni - Pagina 8

Sfoglia online o scarica il pdf Manuale di istruzioni per Trapano Makita 6216DWAE. Makita 6216DWAE 20.

CAUTION:

*The high capacity battery charger Model DC1411 is for charging Makita battery cartridge.

Never use it for other purposes or for other manufacturer's batteries.

*When you charge a new battery cartridge or a battery cartridge which has not been used

for

long period of time, it may not accept a full charge. This is a normal condition and

does not indicate a problem. You can recharge the battery cartridge fully after discharging

completely and recharging a couple of times.

If you charge a battery cartridge from a just-operated tool or a battery cartridge which has

been left in a location exposed to direct sunlight or heat for a long time, the charging light

may flash in red color. If this occurs, wait for a while. Charging will begin after the battery

cartridge cools. The battery cartridge will cool faster if you remove the battery cartridge

from the high capacity battery charger.

*If the charging light flashes alternately in green and red color, a problem exists and charg-

ing is not possible. The terminals on the charger or battery cartridge are clogged with

dust or the battery cartridge is worn out or damaged.

ASSEMBLY

Installing or removing driver bit or drill bit

CAUTION:

Always be sure that the tool is switched off and the battery cartridge is removed before

installing or removing the bit.

Hold the ring and turn the sleeve counter-

clockwise to open the chuck jaws. Place

the bit in the chuck as far as it will go. Hold

the ring firmly and turn the sleeve clock-

wise to tighten the chuck.

To remove the bit, hold the ring and turn

the sleeve counterclockwise.

When not using the driver bit, keep it in the

bit holders. Bits 45 mm (1-3/4") long can be

kept there.