Makita 6217DWDE Informazioni tecniche - Pagina 9
Sfoglia online o scarica il pdf Informazioni tecniche per Trapano Makita 6217DWDE. Makita 6217DWDE 13. Cordless driver drills 10mm, 13mm
Anche per Makita 6217DWDE: Elenco delle parti (2 pagine)
Stampa la pagina
R
epair
< 3 > Disassembling gear assembly and motor section See Fig. 3.
Lifting up mode change lever, separated change ring, gear assembly, yoke, armature and endbell from housing
as a set.
Mode change lever
Change ring
< 4 > Assembling leaf spring See Fig. 5.
Assemble leaf spring to housing L as illustrated in Fig. 4.
Leaf spring
Housing L
< 5 > Assembling change ring
When separating gear assembly from housing, change ring can easily slip off from gear assembly.
Re-assemble change ring to gear assembly as follows.
1. Align the widest bulge of spring holder to the bulge of gear assembly by turning spring holder.
2. Assemble change ring by aligning the bulge of change ring's edge to the portion of gear assembly
marked with circle by the bulge of gear assembly.
The widest bulge of
Bulge of
spring holder
gear assembly
Remove as a set without separating from each other.
Yoke
Gear assembly
Armature
Endbell
Bulge of
change ring's edge
Change ring
< Note in disassembling >
Torsion spring 2
Remove so careful that the following springs
do not spring out.
Compression spring 2: installed in mode change
Torsion spring 2: fixing mode change lever
Fig. 3
Housing L
Fig. 4
Bulge of
gear assembly
Bulge of
change ring's edge
Fig. 5
P 9 / 13
Lock lever
Compression spring 2
Mode change lever
Gear assembly
lever.
on gear assembly