a&p instruments 2001 Series Manuale di istruzioni - Pagina 2

Sfoglia online o scarica il pdf Manuale di istruzioni per Apparecchiature di prova a&p instruments 2001 Series. a&p instruments 2001 Series 10.

Thank you very much for purchasing your new ULTRA X moisture tester.

Please read the following instructions carefully.

[Geben Sie ein Zitat aus dem Dokument oder die Zusammenfassung eines interessanten

Punktes ein. Sie können das Textfeld an einer beliebigen Stelle im Dokument positionieren.

Verwenden Sie die Registerkarte 'Textfeldtools', wenn Sie das Format des Textfelds

'Textzitat' ändern möchten.]

ULTRA X instruments normally work for many years. Should it be necessary however

to send the device to our service department, please use the original packing or ask

us for a new one.

The warranty requires that the devices are handled according to their sensitiveness.

The devices have a built-in mg-balance and may not be exposed to strong shocks.

A broken weighing cell does not come under the warranty.

Safety advices

Transport the instrument only in the upright position

Do not expose the instrument to heavy shocks

Operate the instrument always horizontally and on a vibration-free surface

Parts of sample material shall not fall between the pan holder and the housing, that

will hinder the balance.

Never touch the hot radiator, there is a risk of injury!

Pull out the mains plug before maintaining the instrument

Maintenance should only be done by experts in electric equipment

Take special care when drying inflammable sample materials

Use only accessories in ULTRA X quality

Dispatch the instrument only in the original packing

1. Starting

1.1.

Place the instrument on a horizontal, firm and vibration-free surface.

1.2.

(Not for UX 2081 types)

Set the radiator's height with the calibration stick to 7 – 8 cm between the

reflector's edge and the top surface of the housing. Loosen the screw at

the reflector holder and move the reflector up into the correct position.

1.3.

Swing back the radiator and place a drying pan onto the pan holder by

using the special steel tong (UX 2081 types come along with two tongs)

1.4.

Check the local mains voltage to the instrument's voltage shown on the

identification plate on the backside of the instrument.

1.5.

Connect the instrument to the mains.

1.6.

Start the instrument with the Standby button.