Alipa CODIPRO QLR Manuale di istruzioni - Pagina 3
Sfoglia online o scarica il pdf Manuale di istruzioni per Apparecchiature industriali Alipa CODIPRO QLR. Alipa CODIPRO QLR 3.
Stampa la pagina
For the routine check, perform the following steps:
• Ensure the integrity of the lifting accessory and its components:
o bolt
o shackle
o flange
o base
o push button
o threaded inserts
o screw head
o inner shaft
• Make sure that the safety devices function correctly.
o Push button engagement: the stop actuation must
allow the shaft, located inside the bolt, to come flush
with the lower-end surface of the bolt and the inserts to
retract completely.
• Ensure that the conform markings are present.
• Ensure that the accessory has not been subjected to impacts for which it was not intended.
• Ensure that the accessory has not been subjected to plastic deformation.
• Ensure there are no cracks.
• Ensure that the joints are working properly.
• Ensure there is no excessive or abnormal wear.
The inspection must be carried out by competent persons at least once a year for normal use, several times a year for intensive use.
Routine checks should be performed first. In addition, the following checks must be carried out :
• Condition and wear of the threaded inserts
• Compatibility of the thread - thread hole with thread ring gauges
• Condition of the push button spring
• Condition of the bolt, screw head and the other components
• Articulation of the moving parts
• Correct operation of the anchoring mechanism
• Correct assembly of the components
• Abnormal wear and/or corrosion
• Deformation
• CE marking, traceability engravings, WLL
The accessory must be kept clean. Use a damp cloth for cleaning. Ensure that no particles can interfere with the function of the joints.
Ensure that the markings remain legible. Regularly check the parts for wear and tear. All parts of the accessory are subject to stress
and wear and may need to be replaced after prolonged use. If a problem is detected during an inspection, do not use the equipment
again until the problem has been solved. An unsolved problem can cause serious or lethal accidents.
If it is determined that the equipment can no longer be used under normal conditions, ensure that the equipment is no longer being
used, for example by sealing it or completely destroying the accessory.
Most of the materials used are recyclable. Consult local regulations in terms of recycling and reuse.
Engaging the push button
SERVICING AND MAINTENANCE
QLR instruction manual - translation of the French original version
Conform with the Machinery Directive 2006/42/EC
www.codipro.net - [email protected]
25, Salzbaach – LU-9559 WILTZ – Tél : +352 26 81 54 1 - Fax : +352 81 05 17
ROUTINE CHECKS
o Release of the push button: the button must be able to
spring out automatically and allow the threaded inserts to
fully extend and engage.
DECOMMISSIONING
RECYCLING
Release of the push button
02.2021