Garmin ZUMO 396 LMT-S Europe Manuale d'uso - Pagina 6
Sfoglia online o scarica il pdf Manuale d'uso per GPS Garmin ZUMO 396 LMT-S Europe. Garmin ZUMO 396 LMT-S Europe 32.
Stampa la pagina
Attaching the Base Plate to the Motorcycle Mount
Direct, sustained contact with the base plate or any part of the
motorcycle may damage the mount over time. To prevent this
kind of damage, you must place the mounting spacers between
the mount and base plate, and make sure that no part of the
device or mount touches the motorcycle.
1
Thread the M4 x 20 mm panhead screws
washers
, cradle, spacers
2
Tighten the nuts to secure the base plate.
Attaching the Base Plate to the Handlebar Base
1
Align the ball of the handlebar base
base plate
with each end of the double-socket arm
2
Insert each ball into the double-socket arm.
3
Tighten the knob slightly.
4
Adjust for optimal viewing and operation.
5
Tighten the knob to secure the mount.
Installing your device in the motorcycle mount
1
Fit the left side of your device into the cradle.
2
NOTICE
through the
and base plate
.
and the ball of the
2
Push the right side of the device forward until it snaps into
place.
3
If the latch
on the mount stays up after you insert the
device, press it down.
Removing Your Device from the Motorcycle
Mount
1
Press the release button on the bottom of the mount.
2
Lift out the device.
Mounting Your Device in an Automobile
Before mounting the device, check the local laws pertaining to
windscreen mounting.
This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
Do not use the suction cup mount on a motorcycle.
See the Important safety and product information guide in the
product box for product warnings and other important
information.
NOTE: the automobile mount is not included with all device
models. Go to
garmin.com
.
1
Plug the automotive power cable
mount.
2
Remove the clear plastic from the suction cup
3
Clean and dry your windscreen and the suction cup with a
lint-free cloth.
4
Press the suction cup to the windscreen, and flip the lever
back toward the windscreen.
5
Snap the cradle
6
Fit one side of your device into the cradle.
7
Press the device into the cradle until it snaps into place.
NOTICE
WARNING
to purchase optional accessories.
into the port
onto the suction cup arm.
on the
.
Installation