Brother 885-X11 Manuale operativo - Pagina 38

Sfoglia online o scarica il pdf Manuale operativo per Macchina da cucire Brother 885-X11. Brother 885-X11 44.
Anche per Brother 885-X11: Manuale operativo (44 pagine), Manuale operativo (44 pagine), Manuale operativo (44 pagine)

Stampa la pagina

APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

APPENDIX

MAINTENANCE

Restrictions on oiling

In order to prevent damaging this machine, it must not

be oiled by the user.

This machine was manufactured with the necessary

amount of oil applied to ensure correct operation,

making periodic oiling unnecessary.

If problems occur, such as difficulty turning the

handwheel or an unusual noise, immediately stop using

the machine, and contact your authorized dealer or the

nearest authorized service center.

Precautions on storing the

machine

Do not store the machine in any of the locations

described below, otherwise damage to the machine

may result, for example, rust caused by condensation.

• Exposed to extremely high temperatures

• Exposed to extremely low temperatures

• Exposed to extreme temperature changes

• Exposed to high humidity or steam

• Near a flame, heater or air conditioner

• Outdoors or exposed to direct sunlight

• Exposed to extremely dusty or oily environments

Note

● In order to extend the life of this machine,

periodically turn it on and use it.

Storing this machine for an extended period

of time without using it may reduce its

efficiency.

Cleaning

CAUTION

●

Make sure you unplug the machine

before you clean it, otherwise you risk

getting an electric shock or being

injured.

Turn off the machine and unplug it.

Raise the needle and the presser foot.

Loosen the presser foot screw and the

needle clamp screw to remove the presser

foot holder and the needle.

Using the oval screwdriver, remove the

two screws. Lift up the needle plate as

shown in the illustration, and then slide

the needle plate to the left to remove it.

1 Use the oval screwdriver

Grasp the bobbin case, and then lift it out

to the left.