Garmin Fishfinder 320C Manuale dei modelli

Sfoglia online o scarica il pdf Manuale dei modelli per Sistema GPS marino Garmin Fishfinder 320C. Garmin Fishfinder 320C 1. Sunlight-readable color sonar
Anche per Garmin Fishfinder 320C: Manuale d'uso e manuale di riferimento (38 pagine), Specifiche tecniche (2 pagine), Specifiche tecniche (2 pagine)

FLUSH MOUNT TEMPLATE

GPSMAP 188C/198C & FISHFINDER 320C

UNIT OUTLINE

CUT MOUNTING SURFACE

ALONG INSIDE OF THIS LINE

Be very careful when cutting this hole,

there is only a small amount of clearance

between the unit and the Mounting Holes.

Drill four 3mm (1/8") mounting holes at the indicated locations.

Install the four Mounting Studs into unit by screwing the shorter section in to

the back of the unit.

Use a 1/16" (2mm) Allen Wrench to tighten the Mounting Studs until the stop

contacts the case. Be careful not to overtighten as this may damage the

Mounting Stud! The studs have a reusable thread-locking patch pre-applied from

the factory.

Place the unit in position in the cut out in the mounting surface.

Place washers over the Mounting Studs, then thread on one Hex Nut per

Mounting Stud.

Tighten all four until the unit is snug against the mounting surface.

Install and tighten the second Hex Nut on all four Mounting Studs to lock

the first one in place.

Garmin International, Inc. 1200 East 151st Street, Olathe, Kansas 66062, U.S.A.

Part Number 190-00264-00 Rev. D

TRIM TEMPLATE ALONG THIS LINE TO AID FITTING

110.0 mm

(4.33")

www.garmin.com

February 2005 Printed in Taiwan

DRILL A 3/8" HOLE.

BEGIN CUTTING HERE.

3.0 mm

(1/8")

141.6 mm

(5.58")