Garmin GPS 16-HVS Specifiche tecniche - Pagina 23

Sfoglia online o scarica il pdf Specifiche tecniche per Sistema GPS marino Garmin GPS 16-HVS. Garmin GPS 16-HVS 37. Instruction manual
Anche per Garmin GPS 16-HVS: Manuale di istruzioni (30 pagine), Manuale di riferimento (1 pagine), Specifiche tecniche (40 pagine), Dichiarazione di conformità (2 pagine), Manuale di istruzioni (30 pagine)

Stampa la pagina

1. Gps 16/17 Wiring Diagrams

4.2.14 3D Velocity Information (PGRMV)

$PGRMV,<1>,<2>,<3>*hh<CR><LF>

<1>

True east velocity, -514.4 to 514.4 meters/second

<2>

True north velocity, -514.4 to 514.4 meters/second

<3>

Up velocity, -999.9 to 999.9 meters/second

4.2.15 DGPS Beacon Information (PGRMB)

Note: PGRMB is not supported at this time.

$PGRMB,<1>,<2>,<3>,<4>,<5>,K,<6>,<7>*hh<CR><LF>

<1>

Beacon tune frequency, 0.0, 283.5–325.0 kHz in 0.5 kHz steps

<2>

Beacon bit rate, 0, 25, 50, 100, or 200 bps

<3>

Beacon SNR, 0 to 31

<4>

Beacon data quality, 0 to 100

<5>

Distance to beacon reference station in kilometers

<6>

Beacon receiver communication status (0 = Check Wiring, 1 = No Signal, 2 = Tuning, 3 = Receiving, 4=

Scanning)

<7>

DGPS fix source (R = RTCM, W = WAAS, N = Non-DGPS Fix)

<8>

DGPS mode, A = Automatic, W = WAAS Only, R = RTCM Only, N = None (DGPS disabled)

4.3

Baud Rate Selection

Baud rate selection can be performed by sending the appropriate configuration sentence to the GPS sensor as

described in the $PGRMC Section

4.4

One-Pulse-Per-Second (PPS) Output

The highly accurate one-pulse-per-second (PPS) output is provided for applications requiring precise timing

measurements. The signal is generated after the initial position fix has been calculated and continues until power

down. The rising edge of the signal is synchronized to the start of each GPS second. Regardless of the selected baud

rate, the information transmitted by the GPS sensor is referenced to the pulse immediately preceding the NMEA

0183 RMC sentence.

The accuracy of the one-pulse-per-second output is maintained only while the GPS sensor can compute a valid

position fix. To obtain the most accurate results, the one-pulse-per-second output should be calibrated against a local

time reference to compensate for cable and internal receiver delays and the local time bias.

The default pulse width is 100 ms, however; it may be programmed in 20 ms increments between 20 ms and 980 ms

as described in $PGRMC Section

4.5 Received RTCM Data

Position accuracy of less than 5 meters can be achieved with the GPS 16/17 series products by using Differential

GPS (DGPS) real-time pseudo-range correction data in RTCM SC-104 format, with message types 1, 2, 3, 7, and 9.

These corrections can be received by the GPS 16/17 series products on COM 2. The RTCM data must be received at

the same baud rate as the COM 1 port. For details on the SC-104 format, refer to RTCM Paper 134-89/SC 104-68 by

the Radio Technical Commission for Maritime Services.

190-00228-21

4.1.3 Sensor Configuration Information

GPS 16/17 Technical Specifications

Page 19

(PGRMC), field <10>.

(PGRMC), field <13>.

Rev. A