Garmin GPS 17 Series Manuale di istruzioni per l'installazione - Pagina 8

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Sistema GPS marino Garmin GPS 17 Series. Garmin GPS 17 Series 19. Technical specifications
Anche per Garmin GPS 17 Series: Manuale di istruzioni per l'installazione (16 pagine), Manuale di istruzioni per l'installazione (17 pagine), Specifiche tecniche (37 pagine)

Garmin GPS 17 Series Manuale di istruzioni per l'installazione
I
I
NSTALLATION
NSTRUCTIONS

Wiring and Cables

The GPSMAP 3006C/3010C comes with an 18-pin Power/NMEA and a 17-pin Marine Video cable. Optional Garmin Marine Network
components use specialized Garmin Network cables. For some installations, it may be necessary to drill 1.25" (31.7 mm) holes to route the
connector end of the cables. Garmin rubber grommets are provided to cover the installation holes (see below). Wiring instructions are found
on the following pages. If you experience difficulty installing the unit, contact Garmin Product Support or seek the assistance of a
professional installer.
The grommets may not be needed in some installations. The grommets do NOT create a waterproof seal. Apply a marine sealant after
installation to weatherproof around the grommet and cable. Additional grommets can be purchased from your Garmin dealer or direct from
Garmin. Be sure to test the system before installing the grommets.
Tools
• Drill
• 1.25" (31.7 mm) paddle drill bit or hole saw
• Utility knife
• Marine sealant (optional)
To install the Cable Grommet:
1. Mark the location where the cable Power/Data, Marine Video, or Marine Network cable is to route through.
2. Using a 1.25" (31.7 mm) paddle drill bit or hole saw, drill the installation hole.
3. Refer to the diagram below for trimming instructions. Carefully trim the cable hole, as needed.
4. Route the cable to the unit.
5. Spread the grommet apart at the split ,and place it around the cable (see below).
6. Firmly push the grommet into the installation hole until it is seated. Apply marine sealant, as needed, to weatherproof the cable.
Trim out to this line for
the Marine Video Cable
6
Use this hole (no trim) for the Power/Data,
Marine Network, or GPS 17 Cable
Split
GPSMAP 3006C/3010C & GPS 17