Garmin GPS 17HVS - Receiver Module Specifiche tecniche - Pagina 27

Sfoglia online o scarica il pdf Specifiche tecniche per Sistema GPS marino Garmin GPS 17HVS - Receiver Module. Garmin GPS 17HVS - Receiver Module 37. Declaration of conformity
Anche per Garmin GPS 17HVS - Receiver Module: Manuale di istruzioni per l'installazione (12 pagine), Specifiche tecniche (34 pagine), Manuale di installazione (16 pagine), Specifiche tecniche (40 pagine), Dichiarazione di conformità (2 pagine)

Garmin GPS 17HVS - Receiver Module Specifiche tecniche

APPENDIX B: BINARY PHASE OUTPUT FORMAT

Note: The following applies to all software versions of GPS 16LVS, GPS 16HVS, and GPS 17HVS.
Two records are transmitted once per second by the GPS 16/17 series products. One record contains primarily post-
process information, such as position and velocity information. The second record contains receiver measurement
information. The records are sent at a default baud rate of 9600 baud, 8 data bits, and no parity.
Records begin with a delimiter byte (10 hex). The second byte identifies the record type (33 hex for a position
record, 34 hex for a receiver measurement). The third byte indicates the size of the data. The fourth byte is the first
byte of data. The data is then followed by a checksum byte, a delimiter byte (10 hex), and an end-of-transmission
character (03 hex).
Note: If RTCM-104 differential data is sent to the GPS sensor, the board will reset the Phase Output Data baud rate
to the same baud rate used for RTCM-104 data. If the differential inputs are used on the GPS sensor, the RTCM-104
data must be sent to the GPS sensor at 9600 baud (preferred) or 4800 baud. RTCM-104 baud rates less than 4800
baud are not supported by the GPS sensors as it would limit bus bandwidth past the point where a once-per-second
phase output data rate could be maintained.

Position Record

- 0x10
(DLE is first byte)
- 0x33
(Position record identifier)
- 0x40
(Size of data)
- cpo_pvt_data
(See description below)
- one-byte checksum
(The addition of bytes between the delimiters should equal 0)
- 0x10
(DLE)
- 0x03
(ETX is last byte)
typedef struct
{
float
alt;
float
epe;
float
eph;
float
epv;
int
fix;
double
gps_tow;
double
lat;
double
lon;
float
lon_vel;
float
lat_vel;
float
alt_vel;
float
msl_hght;
int
leap_sec;
long
grmn_days;
} cpo_pvt_data;
190-00228-21
GPS 16/17 Technical Specifications
Page 23
Rev. A