Garmin GPSMAP 3005C Manuale dei modelli

Sfoglia online o scarica il pdf Manuale dei modelli per Sistema GPS marino Garmin GPSMAP 3005C. Garmin GPSMAP 3005C 1. Declaration of conformity
Anche per Garmin GPSMAP 3005C: Manuale di riferimento rapido (2 pagine), Manuale di istruzioni per l'installazione (10 pagine), Riferimento rapido (2 pagine), Manuale di istruzioni per l'installazione (17 pagine), Dichiarazione di conformità (1 pagine)

GPSMAP 3005C FLUSH MOUNT TEMPLATE

CUT THE MOUNTING SURFACE

ON THE INSIDE OF THIS LINE.

Be very careful when cutting. There is 1/8"

clearance between the case and the

mounting stud holes. If the cutout is tight, file

or sand the cutout to obtain the correct fit.

DRILL A 3/8"

Garmin International

DRILL THE 1/8" (3 mm)

MOUNTING HOLES

BEFORE CUTTING.

To flush mount the GPSMAP 3005C:

1. Trim the Flush Mount Template for fit and tape it in the desired location.

2. Using a center punch, indent the center of each mounting hole location.

3. Drill the four mounting holes using a 1/8" (3 mm) drill bit.

4. Drill a 3/8" (6 mm) hole to begin cutting the mounting surface.

5. Cut along the inside of the indicated line. Be very careful when cutting this hole,

because there is 1/8" clearance between the case molding and the mounting holes.

6. Install the four mounting studs into the unit by screwing the shorter, threaded section

into the back of the unit. Use a 1/16" (2 mm) Allen Wrench to tighten the mounting studs

until the stops contact the case. Do not overtighten the studs. The studs have a

factory-applied thread-locking patch.

7. Position the GPSMAP 3005C in the cut out of the mounting surface.

8. Place washers over the mounting studs, then thread on one hex nut per mounting stud.

Tighten all four until the unit is snug against the mounting surface.

Install and tighten the second hex nut on all four mounting studs to lock the first one

into place.

(6 mm)

HOLE

TO START CUTTING.

1200 E. 151st Street, Olathe, KS 66062

5.5" (140.00 mm)

190-00531-03 Rev. B

4.25"

(108.00 mm)

March 2006

Printed in Taiwan