Garmin GPSMAP 4008 - Marine GPS Receiver Manuale di istruzioni per l'installazione - Pagina 5

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Sistema GPS marino Garmin GPSMAP 4008 - Marine GPS Receiver. Garmin GPSMAP 4008 - Marine GPS Receiver 19. Weather and xm satellite radio gpsmap 4000 series; gpsmap 5000 series; gpsmap 6000 series; gpsmap 7000 series
Anche per Garmin GPSMAP 4008 - Marine GPS Receiver: Informazioni importanti (2 pagine), Manuale d'uso (2 pagine), Riferimento tecnico (30 pagine), Manuale di riferimento rapido (2 pagine), Manuale di istruzioni per l'installazione (25 pagine), Manuale di istruzioni per l'installazione (25 pagine), Manuale di riferimento rapido (2 pagine), Importanti informazioni sulla sicurezza (48 pagine), Dichiarazione di conformità (1 pagine), Manuale integrativo (24 pagine)

To attach the enclosed pole mount adapter to the GPS 17:

1. Thread the cable though the pole mount adapter.

2. Align the tab on the pole mount adapter to the notch on the

GPS 17.

3. Use the enclosed screws to secure the pole mount adapter to

the base of the GPS 17.

Attaching the Pole Mount Adapter to the GPS 17

GPSMAP 4000/5000 Series Installation Instructions

Align Notch

To mount the GPS 17 with the cable run outside the

mount:

1. Place the cable in the vertical slot along the base of the

assembled GPS 17 and pole mount adapter.

2. Screw the assembled GPS 17 and pole mount adapter onto

a standard 1" O. D. 14 threads-per-inch marine mount (not

included). DO NOT overtighten the head. Overtightening the

unit may cut the cable.

3. With the GPS 17 installed on the pole mount, fill the remaining

gap in the cable exit with a marine sealant.

4. Fasten the pole mount to the boat if it is not already attached.

5. Route the cable away from sources of electronic interference.

To mount the GPS 17 with the cable run through the

mount:

1. Position a standard 1" O. D. (Outer Dimension), 14 threads-per-

inch marine mount (not included) in the preferred location, and

mark the approximate center of the mount.

2. Drill a hole using a

" (19 mm) drill bit for the cable to pass

through.

3. Fasten the pole mount to the boat .

4. Slide the cable through the pole mount and screw the assembled

GPS 17 and pole mount adapter onto the pole mount.

5. Route the cable away from sources of electronic interference.

Cable run internally

Attaching the GPS 17 to a Pole Mount

Cable run externally