Garmin 30A Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Attrezzatura marina Garmin 30A. Garmin 30A 38. Marine weather satellite receiver

ETTING

TARTED

NSTALLING THE GDL

To obtain the best possible performance, install the GDL 30/30A according to the following

instructions. If you experience difﬁculty during the installation, contact Garmin Product Support or

seek the advice or a professional installer.

Mount the GDL 30/30A in a location that is dry and well-ventilated. Avoid mounting the unit

where it may become submerged or exposed to extreme temperatures. Verify there is enough

clearance to attach the cables to the unit. If you want to view the blink codes, make sure the

Status LED is visible.

To mount the GDL 30/30A:

1. Using the unit as a template, mark the location of the mounting holes. If needed, additional

holes can be drilled in the side mounting ﬂanges.

2. Secure the GDL 30/30A using the appropriate fasteners.

The Power Cable can be connected directly to the vessel's battery or through an open

connector on the fuse block.

To connect the power cable to a battery:

1. Connect the Red wire to the positive (+) terminal of the battery. Do not remove the

AGC/3AG 2.0 amp fuse holder from the Red wire.

2. Connect the Black wire to the negative (-) terminal of the battery.

3. Connect the power cable to the GDL 30/30A 7-pin connector labeled POWER.

To connect the power cable to a fuse block:

1. Remove the AGC/3AG 2.0 amp fuse holder from the Red wire.

2. Connect the Red wire to an open fuse holder in the fuse block. Make sure that the

Red wire is connected to the positive side of the fuse block.

3. Connect the Black wire to the negative side of the fuse block.

4. Install a 2.0 amp fuse in the fuse holder.

5. Connect the power cable to the GDL 30/30A 7-pin connector labeled POWER.

30/30

NSTALLING THE

GDL 30/30A

Connecting to a battery

Connecting to a fuse block

2 amp fuse

Battery +

10-35 Volts

To GDL 30/30A

Battery -

GDL 30/30A Owner's Manual