Garmin GHP 10V Manuale di istruzioni per l'installazione - Pagina 4
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Attrezzatura marina Garmin GHP 10V. Garmin GHP 10V 20. Marine autopilot system
Anche per Garmin GHP 10V: Manuale di istruzioni per l'installazione (48 pagine), Manuale d'uso (28 pagine), Manuale di istruzioni per l'installazione (20 pagine)
Stampa la pagina
Before installing the GHP 10V autopilot system, it is important that you completely understand where all the components will be located on
your boat. Temporarily place all the components where you plan to install them. Ensure that all cables can reach the necessary components
before mounting any of the components.
Electrical/Data Connection and Mounting Considerations
The GHP 10 components connect to each other and to power using the included cables. Ensure that the correct cables reach each component,
and ensure that each component is in an acceptable location before mounting any components. Read the following considerations and consult
the diagram on the next page before you begin installation.
CCU
•
Do not mount the CCU in a location where it will be submerged or exposed to wash-down.
•
Mount the CCu in the forward half of the boat, no higher than 10 ft. (3.05 m) above the waterline.
•
You can mount the CCU below the waterline, as long as it is not in a location where it will be submerged or exposed to wash-down.
•
Mount the CCU bracket on a vertical surface or under a horizontal surface, so that the connected wires hang straight down.
•
Do not mount the CCu near magnetic material, magnets (speakers and electric motors), or high-current wires. Mount the CCU at
least 24 in. (0.61 m) away from movable or changing magnetic disturbances such as anchors, anchor chain, wiper motors, and tool boxes.
Use a handheld compass to test for magnetic interference in the area.
•
The CCU cable connects the CCU to the Autopilot Gateway, and provides 9
Gateway. If you cannot mount the CCU within 9
(not included) to extend the cable. Do not connect the CCu cable to a nMea 2000 network.
•
The CCU cable connects the CCU to power, to the alarm buzzer, and to the yellow CCU signal wire of the GHC 10 using wires with bare
ends. See
page 7
for wiring instructions and diagrams.
CCU and GHC 10
•
The CCU and the GHC 10 connect to a NMEA 2000 network using dedicated NMEA 2000 communication ports. If you do not have a
NMEA 2000 network on your boat, the equipment necessary to build one is provided. For instructions on setting up the NMEA 2000
network, see
page
11.
•
You can connect an optional NMEA 2000-compatible GPS device to the NMEA 2000 network to use waypoint and route data with the
GHP 10.
GHC 10
•
Wire the GHC 10 to the battery of the boat and to the yellow CCU signal wire of the Autopilot Gateway cable.
•
If you do not have an optional NMEA 2000-compatible GPS device, you can wire an optional NMEA 0183-compatible GPS device to the
power/data cable of the GHC 10 instead (see
Preparation
/
ft. (3 m) of the Autopilot Gateway, use a NMEA 2000 drop cable up to 20 ft. (6m) long
1
2
page
12).
/
ft. (3 m) of cable between the CCU and the Autopilot
1
2
GHP 10V Installation Instructions