Garmin Gladiator TR-1 Manuale d'uso - Pagina 18

Sfoglia online o scarica il pdf Manuale d'uso per Attrezzatura marina Garmin Gladiator TR-1. Garmin Gladiator TR-1 36. Garmin tr-1 marine autopilot: user guide
Anche per Garmin Gladiator TR-1: Manuale d'installazione e d'uso (4 pagine), Manuale d'uso (13 pagine)

Stampa la pagina

1. Press and hold [Setup] button on handheld.

2. While holding down the [Setup] button, select and light

up [number 8] LED [Clover] on the handheld. (You will

press the button twice.) Release the Setup button.

3. You must mark the location of the clover leaf stem

with a waypoint in your GPS. Once the waypoint is saved,

select "go to" this waypoint on your GPS.

4. From heading hold, press and release the [GPS button]

on the handheld. The pilot will start maneuvering toward

the waypoint.

If you have selected Clover Leaf pattern as the special function for the Chevron buttons, pressing either

Chevron button will start the boat on the clover leaf pattern. If you used the Right Chevron button the clover

leaf will be traversed by always turning to starboard, the Left Chevron button will cause the pattern to be

traversed while always turning to port. (See Figure 4) The length of one of the clover leaves is programmed

with setup code 28. It is adjustable in length from 500 ft to 6,000 feet in 100 ft. increments. See table below.

To change the setup options for Clover Leaf:

You must be in [Auto] or [STBY] mode before selection process can start

1. Press and release the [Setup] Button. The [Setup] LED will illuminate to indicate the system is ready to

take setup commands (button pushes).

2. Select the Setup Code you want to use by pressing and releasing the button labeled 2 & 8 until the

appropriate LED is lit. (See the Code and Setup Choices on the table below).

3. Increase an adjustable parameter one step by each press of the [UP Arrow] button. When the parameter is

adjusted to its maximum value, the [Up Arrow] LED will light. The parameter is adjusted and is in use by the

autopilot immediately.

4. Decrease an adjustable parameter one step by each press of the [Down Arrow] button. When the

parameter is adjusted to its minimum value, the [Down Arrow] LED will light. The parameter is adjusted and

is in use by the autopilot immediately.

5. To save the changes into permanent memory and make the selected function into a

startup default: Press and release the [Setup] button (the [Setup] LED should be lit),

and then press and hold the [Select Load] button. While holding down the [Select Load]

button, press and release the [Deckmount] On/Off button quickly, then release the GPS

[Select Load] button.

Description

Clover Leaf Length

Clover Leaf Pattern

The clover leaf pattern is intended for use when you wish to repeatedly

pass over a point where you think fish may be holding.

You will need to setup

the special nav function

buttons (above) for

search patterns.

Code

Setup Options (Parameters)

500 to 6,000 ft by 100ft. Increments

Left Chevron

Button Pressed

Waypoint

Selected on GPS

Right Chevron

Button Pressed

Figure 4

Factory Setting

1,000