Garmin Reactor 40 Manuale di istruzioni per l'installazione - Pagina 12

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Attrezzatura marina Garmin Reactor 40. Garmin Reactor 40 25. Mechanical
Anche per Garmin Reactor 40: Manuale di istruzioni per l'installazione (11 pagine), Manuale di istruzioni per l'installazione (13 pagine), Manuale di istruzioni per l'installazione (29 pagine), Manuale di configurazione (8 pagine)

ECU Installation

Mounting the ECU

Before you can mount the ECU, you must select a location and determine the correct mounting hardware

Mounting and Connection Considerations,

1 Hold the ECU in the intended mounting location and mark the locations of the mounting holes on the

mounting surface, using the ECU as a template.

2 Using a drill bit appropriate for the mounting surface and selected mounting hardware, drill the four holes

through the mounting surface.

3 Secure the ECU to the mounting surface using the selected mounting hardware.

Connecting the ECU to Power

When connecting the power cable, do not remove the in-line fuse holder. To prevent the possibility of injury or

product damage caused by fire or overheating, the appropriate fuse must be in place as indicated in the product

specifications. In addition, connecting the power cable without the appropriate fuse in place voids the product

warranty.

You should connect the ECU power cable directly to the boat battery, if possible. Although it is not

recommended, if you connect the power cable to a terminal block or other source, you must connect it through

a 40 A fuse.

If you plan to route the ECU power through a breaker or a switch near the helm, you should consider using an

appropriately sized relay and control wire instead of extending the ECU power cable.

1 Route the connector-terminated end of the ECU power cable to the ECU, but do not connect it to the ECU.

2 Route the bare-wire end of the ECU power cable to the boat battery.

If the wire is not long enough, it can be extended

3 Connect the black wire (-) to the negative (-) terminal of the battery, and connect the red wire (+) to the

positive (+) terminal of the battery.

4 After you install all of the other autopilot components, connect the power cable to the ECU.

You should apply dielectric grease to the pin holes on the cable connector to prevent corrosion, especially if

you are using the autopilot system in saltwater.

Power Cable Extensions

If necessary, you can extend the power cable using the appropriate wire gauge for the length of the extension.

Item

Description

Fuse

Battery

9 ft. (2.7 m) no extension

page 8).

WARNING

(Power Cable Extensions,

NOTICE

page 12).

(ECU