Garmin VHF 315 Series Manuale di istruzioni per l'installazione - Pagina 6
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Radio marina Garmin VHF 315 Series. Garmin VHF 315 Series 15.
Anche per Garmin VHF 315 Series: Manuale di istruzioni per l'installazione (6 pagine), Manuale d'uso (32 pagine)
Stampa la pagina
GHS 11 Mounting Considerations
This device should be mounted in a location that is not exposed to extreme temperatures or conditions. The
temperature range for this device is listed in the product specifications. Extended exposure to temperatures
exceeding the specified temperature range, in storage or operating conditions, may cause device failure.
Extreme-temperature-induced damage and related consequences are not covered by the warranty.
• You must install the primary handset (connected to the GHS 11 STATION 1 port) in the wheelhouse or an
adjacent room, in accordance with FCC law.
• To avoid interference with a magnetic compass, do not install the handset closer than 60 cm (23.6 in.) to a
compass.
• If you do not install the active speaker, you can use the included 10 m (32 ft.) extension cable to connect the
handset to the VHF radio. You must select a mounting location for the handset where you can connect the
extension cable to the handset and to the GHS 11 STATION 1 port on the VHF radio. If needed, additional
extension cables are available from your Garmin dealer.
• You can use the included screws to mount the handset connector and the handset cradle mount on your
boat. If the included screws are not appropriate for the mounting surface, you must purchase suitable
hardware.
Installing the Handset Cradle
You should install the handset connector in the mounting surface before installing the handset cradle
the Handset Connector in the Mounting Surface, page
1 Select a mounting location for the handset cradle near the handset connector.
TIP: To help determine the best location, you can place the handset in the cradle, connect the handset to the
connector, and hold it against the mounting surface.
2 Using the cradle as a template, mark the screw locations.
3 Set the cradle aside.
Do not drill through the cradle.
1
4 Using a 3 mm (
/
in.) drill bit, drill the pilot holes.
8
5 Using the included M3.5 screws, secure the cradle to the mounting surface.
Connection Considerations
You must connect the VHF 315 radio to power, to a GHS 11 handset, a VHF antenna, and a GPS source. When
making connections to the device, observe the following considerations.
• You must connect the primary handset (installed in the wheelhouse or adjacent room, in accordance with
FCC law) to the GHS 11 STATION 1 port.
• You can connect up to three handsets to the radio. You can purchase additional handsets from your Garmin
dealer.
• You can install the included active speaker (optional) in-line with any handset connected to the radio. You
can purchase additional active speakers from your Garmin dealer.
• You can connect the radio to a GPS source through the NMEA 2000
antenna (not included).
Connecting to Power
1 Route the power wiring cable to the power source and to the device.
2 Connect the red wire to the positive (+) battery terminal, and connect the black wire to the negative (-)
battery terminal.
Additional Grounding Considerations
This device should not need any additional chassis grounding in most installation situations. If interference is
experienced, the grounding screw on the housing can be used to connect the device to the water ground of the
boat to help avoid the interference.
6
NOTICE
5).
®
network or through an external GPS
(Installing