Garmin T20 Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Prodotto per la cura degli animali domestici Garmin T20. Garmin T20 14. Dog collar device

Charging the Dog Collar Device

To prevent corrosion, thoroughly dry the contacts on the dog collar device and the surrounding area before

connecting the charging clip.

You should fully charge the battery before you use the dog collar device for the first time. Charging a fully

depleted battery takes about five hours.

1 Snap the charging clip

2 Plug the small end of the power cable into the USB port on the charging clip.

3 Plug the power cable into a power source.

The status LED is solid red when the collar is charging.

4 After the status LED turns solid green, remove the charging clip from the collar.

Both the dog collar device and navigator must acquire satellite signals before you put the dog collar device on

your dog. Acquiring satellites can take a few minutes.

1 Go outdoors to an open area.

2 Turn on both devices.

in the status bar shows the GPS signal strength.

When the dog collar device has acquired satellite signals, the status LED flashes green.

Adding a Dog to the Alpha

To pair wirelessly, the dog collar device must be within range of the Alpha navigator.

1 Hold the power button on the dog collar device until the device emits two series of beeps (about 2 seconds),

and then release the power button.

The status LED flashes blue. The dog collar device is now ready to be paired with a navigator.

2 On the navigator, select Dog List > Add Dog.

3 Select Pair Collar, and follow the on-screen instructions.

4 After successfully adding the dog collar device, enter the name of the dog, and select

5 Select a beacon color for this dog collar device, and select

NOTICE

onto the dog collar device

Navigator Using Wireless Pairing

Getting Started