Brother XL5050 Manuale operativo - Pagina 16

Sfoglia online o scarica il pdf Manuale operativo per Macchina da cucire Brother XL5050. Brother XL5050 45. Brother sewing machine operation manual

Stampa la pagina

XL5000us.book Page 15 Tuesday, November 11, 2003 9:25 AM

THREADING THE MACHINE

Winding the Bobbin

CAUTION

Only use the bobbin (part code: SA156,

SFB (XA5539-151)) that has been

designed for this sewing machine. Using

of any other bobbin may cause damage

to the machine.

The bobbin was designed specifically for

this sewing machine. If bobbins from older

models are used, the machine will not

operate correctly. Use only the enclosed

bobbin or bobbins of the same type (part

code: SA156, SFB (XA5539-151)).

Actual size

11.5 mm

(7/16")

Put the spool of thread on the spool pin and

pass the thread around the bobbin-winding

tension disc.

1 Bobbin-winding tension disc

2 Bobbin-winding shaft

CAUTION

If the spool of thread is not in the right

place, the thread may tangle on the spool

pin.

Pass the end of the thread through the hole on

the bobbin from the inside of the bobbin.

Put the bobbin onto the bobbin-winding shaft

and slide the bobbin-winding shaft to the

right. Turn the bobbin clockwise, by hand,

until the spring slides into the slit.

1 Spring

2 Slit

While holding the end of the thread, gently

press the foot controller to wind the thread

around the bobbin a few times. Then, stop the

machine.

Trim the excess thread above the bobbin and

continue winding the thread onto the bobbin

by pressing the foot controller.

Note

G The machine stops automatically when the

bobbin is full.

After the machine stops, cut the thread, slide

the shaft to the left, and then remove the

bobbin.

Note

G The needle bar does not move after the

bobbin-winding shaft is slid to the right.

G Immediately after winding the bobbin, it is

normal to hear the sound of the clutch

engaging when beginning to sew or turning

the balance wheel.