Fujitsu ABT series Manuale operativo - Pagina 12

Sfoglia online o scarica il pdf Manuale operativo per Condizionatore d'aria Fujitsu ABT series. Fujitsu ABT series 20. Floor console/under ceiling dual type
Anche per Fujitsu ABT series: Manuale operativo (18 pagine), Manuale operativo (20 pagine), Manuale operativo (20 pagine)

Stampa la pagina

CLEANING AND CARE

CAUTION!

Cleaning the Air Filter

When the FILTER Lamp is blinking, remove

the filter and clean it.

1. Pull out both sides and the center of the

intake grille.

About 30 mm

Arm

Intake Grille

2. Pull the air filters upward to remove them.

Push the air filter handles away from the intake grille in

direction 1, then pull out the air filters.

Handle

3. Clean the air filters.

Remove the dust from the air filters by vacuuming or

washing them. After washing, allow the air filters to dry

thoroughly in an area protected from sunlight.

G When used for extended periods, the unit may accumulate dirt inside, reducing its performance. We recommend that the

unit be inspected regularly, in addition to your own cleaning and care. For more information, consult authorized service

personnel.

G When cleaning the unit's body, do not use water hotter than 40 °C, harsh abrasive cleansers, or volatile agents like

benzene or thinner.

G Do not expose the unit body to liquid insecticides or hairsprays.

G If the unit will not be operated for a period of one month or more, be sure to allow the inner parts of the unit to dry

thoroughly, in advance, by operating the unit in fan mode for half a day.

G Before cleaning the air conditioner, be sure to turn it off and disconnect the power supply cord.

G Be sure the intake grille is installed securely.

G When removing and replacing the air filters, be sure not to touch the heat exchanger, as per-

sonal injury may result.

Side Panel

Hook

Notch

Arm

Air Filter

Bracket

Base

Intake Grille

4. Re-attach the air filters to the intake grille.

1 The air filters fit onto the inside of the intake grille.

(Figure 1)

2 The bottom edges of the air filters should fit into the

filter brackets. (Figure 1)

3 The air filters should be pushed down so that their

top edges fit under the projections at the top of the

intake grille. (Figure 2)

Air Filter

(Figure 1)

Filter bracket

5. Push in both sides and the center of the

intake grille.

G Dust can be cleaned from the air filter either with a vacuum

cleaner, or by washing the filter in a solution of mild de-

tergent and warm water. If you wash the filter, be sure to

allow it to dry thoroughly in a shady place before rein-

stalling.

G If dirt is allowed to accumulate on the air filter, air flow

will be reduced, lowering operating efficiency and increas-

ing noise.

G After turning the power on, press the filter button on the

remote control to turn off the filter lamp.

(Figure 2)