AEG 25742 GM Istruzioni per l'uso e l'installazione - Pagina 16

Sfoglia online o scarica il pdf Istruzioni per l'uso e l'installazione per Piano cottura AEG 25742 GM. AEG 25742 GM 20. Aeg cooktop user manual

Replacing the power supply lead

If the lead has to be replaced, only HO5RR-F or HO5RN-F type cables suitable for

the load and the operating temperature must be used.In addition, the yellow/green

earth wire must be about 2 cm longer than the live and neutral wires.

In all cases, the power supply lead must be positioned so that it does not reach a

temperature 50 C above the room temperature in any point.

One example of an ideal route is shown in the illustration.The cable is guided by

means of band clamps fixed to the side of the cabinet, in order to avoid any contact

with the appliance underneath the hob.

Adapting to the different types of gas

Changing the nozzles

1) Remove the pan stands

2) Remove the burner caps and flame caps from the

burners.

3) Use a size 7 socket wrench to unscrew and remove

the nozzles, replacing them with those corresponding

to the type of gas to be used (see table).

4) Reassemble the parts, reversing the operations

described above.

5) Then replace the setting data plate (close to the

mains gas connection) with the one for the new type

of gas (it is in the bag of nozzles provided).

If the pressure of the gas used is different from that specified (or variable), a suitable

piped gas pressure regulator complying with the standard must be installed on the

supply pipeline.

Setting the minimum level

1) Light the burner as already described.

2) Turn the tap to the minimum flame position.

3) Remove the control knobs.

4) Use a thin straight screwdriver to turn the by-pass pin located

next to the tap rod (see fig. A).If you are converting from natural

gas to LPG, turn the by-pass pin fully clockwise.

The result should be a small, homogeneous flame which is

uniform around the entire burner ring.

5) Finally, check that the burner does not go out when the tap is

turned quickly from the maximum to the minimum position.