AEG L 61470 BI Manuale d'uso - Pagina 23

Sfoglia online o scarica il pdf Manuale d'uso per Lavatrice AEG L 61470 BI. AEG L 61470 BI 36. Washing machines
Anche per AEG L 61470 BI: Manuale d'uso (36 pagine)

Stampa la pagina

Problem

The appliance does not

fill with water properly.

The appliance does not

drain the water.

The spin phase does not

operate or the washing

cycle lasts longer than

usually.

There is water on the

floor.

You cannot open the ap-

pliance door.

The appliance makes an

unusual noise.

The washing results are

not satisfactory.

You cannot set an op-

tion.

Possible solution

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is not too

low. For this information, contact your local water authority.

• Make sure that the water tap is not clogged.

• Make sure that the sink spigot is not clogged.

• Make sure that the drain hose has no kinks or bends.

• Make sure that the drain filter is not clogged. Clean the fil-

ter, if necessary. Refer to 'Care and cleaning'.

• Make sure that the drain hose is in the correct position. The

hose may be too low.

• Set the drain programme if you set a programme without

drain phase.

• Set the drain programme if you set an option which ends

with water in the tub.

• Set the spin programme.

• Adjust manually the items in the tub and start the spin

phase again. This problem may be caused by balance prob-

lems.

• Make sure that the couplings of the water hoses are tight

and there is not water leakages.

• Make sure that the drain hose have no damages.

• Make sure you use the correct detergent and the correct

quantity of it.

• Make sure you have replaced the emergency emptying cap

into the filter

• Make sure you have properly screwed the filter in after

cleaning.

• Make sure that the washing programme is finished.

• Set the drain or the spin programme if there is water in the

drum.

• Make sure the levelling of the appliance is correct. Refer to

'Installation'.

• Make sure that the packaging and/or the transit bolts are

removed. Refer to 'Installation'.

• Add more laundry in the drum. The load may be too small.

• Increase the detergent quantity or use a different deter-

gent.

• Use special products to remove the stubborn stains before

you wash the laundry.

• Make sure that you set the correct temperature.

• Decrease the laundry load.

• Make sure that you press only the wanted button(s).

ENGLISH