Brother P-Touch QL-500 Manuale d'uso - Pagina 12

Sfoglia online o scarica il pdf Manuale d'uso per Etichettatrice Brother P-Touch QL-500. Brother P-Touch QL-500 19. Quick setup guide - spanish
Anche per Brother P-Touch QL-500: Manuale di avvio rapido (2 pagine), Opuscolo (6 pagine), Manuale di avvio rapido (2 pagine), Manuale di avvio rapido (2 pagine), Manuale di installazione del software (15 pagine), Manuale di avvio rapido (2 pagine), Guida rapida (inglese) (2 pagine)

Getting started

Lift the label lever and then thread the

end of the DK Roll into the slot

immediately before the cutter.

When unable to thread the end of the DK

Roll into the slot, thread it as far as

possible, then lower the label lever and

close the cover. Press the ON/OFF button

to turn the QL-500/560 on, and then press

the FEED button to set the roll.

Lower the label lever and then close the DK

Roll compartment cover.

3 Installing the paper guide

Your QL-500/560 comes with a

paper guide that collects strips of

printed labels that have not been

cut off from the machine.

Attach the paper guide to the front of

the QL-500/560 as shown in the figure.

Remove the paper guide when printing

more than 10 labels continuously and

cutting each label automatically

(QL-560 only).

Connect the AC power cord to the QL-500/560 and

then plug the power supply cord into a standard

electrical socket.

Check that the electrical socket is 220 ~ 240 V before inserting

•

the plug.

Remove the power supply cord from the electrical socket after

•

you have finished using the QL-500/560.

Do not pull the cord when removing it from the electrical

•

socket. The wire in the cord may become damaged.

Paper guide