2N EasyGate Pro Avvio rapido

Sfoglia online o scarica il pdf Avvio rapido per Porta d'ingresso 2N EasyGate Pro. 2N EasyGate Pro 4. Umts gateway
Anche per 2N EasyGate Pro: Avvio rapido (2 pagine), Avvio rapido (4 pagine), Avvio rapido (4 pagine)

Stampa la pagina

Outgoing call

 Suppose that the SIM card has been

inserted, the PIN entered or not required,

and EasyGate is registered to the network

– the LED Mobile network is permanently

on.

 Hook off the telephone, you can hear the

dial tone and the Line LED starts flashing.

 Dial the subscriber number. EasyGate

receives tone dialing (DTMF) by default.

If your telephone transmits pulse dialing

only, program EasyGate to receive pulse

dialing. When you make a delay in your

dialing longer than 5s (programmable),

the connection is established.

 If the called subscriber is available, you

can hear the ringing tone. If not, you can

hear the busy tone or any of the mobile

network provider's messages.

 When the called subscriber answers the

call, the call is established. The Line LED

is permanently on during the call.

 Hang up to terminate the call. The Line

LED goes off. If the called subscriber is

the first to hang up, you can hear the

busy tone, you have to hang up.

Incoming call

 An incoming call is signaled by ringing.

The Line LED flashes during ringing.

 Hook off the phone to establish the call.

The Line LED is permanently on during

the call.

 For call termination see the Outgoing call

section.

In the GSM network data transfer is suspended during voice calls and do

not continue until the voice call is finished. UMTS network is able to

transfer data concurently with voice.

EC Declaration of Conformity

Hereby, 2N TELEKOMUNIKACE a.s., declares that the 2N® EasyGate PRO UMTS product is in compliance with

the essential requirements and other relevant provisions of Directive 1999/5/EC. Refer to the CD-ROM or our

website www.2n.cz for the Declaration of conformity.

Configuration over USB

 For

PC configuration of

necessary

Connect EasyGate to PC using USB cable.

 Virtual serial port(USB serial port FTDI) is

created immediately after linking PC and

EasyGate.

This

PCManager

EasyGate. When the port isn't activated

automatically use driver on CD

 The COM port number of virtual serial

port has to be set in PCManager.

 Detailed description is in the product

manual on CD-ROM.

Data connection over USB

 Easy Gate can be used for high speed

connection to internet (up to 3,6 Mbps

download).

 You have to install USB drivers for UMTS

module. Drivers are on CD-ROM. You

have to select 32 bit drivers or 64 bit

drivers according to your system.

 For internet connection you must set the

APN. Use PCManager, select GSM&SIM

menu and set APN to the APN name of

your mobile internet provider.

 You have to set phone connection in your

PC using Network connection setting.

Select modem 'SimTech HS-USB Modem

9000'

for

this

connection

parameters

Password, Dial number) according to

information from your mobile provider

(obviously Username 'internet', Keyword

is empty an Dial number *99***1#).

 Finally use button 'Dial' to establish

connection to internet.

EasyGate

install

PCManager UNI.

port

used

communicate

connection.

Set

(Username,

with

the