Fujitsu PRIMERGY TX300 S3 Manuale di servizio supplementare - Pagina 31

Sfoglia online o scarica il pdf Manuale di servizio supplementare per Server Fujitsu PRIMERGY TX300 S3. Fujitsu PRIMERGY TX300 S3 47.

Replacement routines

Figure 12: Removing the screws

Ê Remove the two screws (see the arrows) and take out the intrusion switches

inward.

Ê Pull the first removed intrusion switch out of the cable clamp.

Ê Remove the intrusion switch cable from the connector on the system board

(see also the Technical Manual of the system board).

CAUTION!

Note the cable routing.

Ê Plug the new intrusion switch cable to the connector on the system board.

Ê Route the intrusion switch cable. Lay the intrusion switch with the two wires

over the server's edge as shown in the figure above.

Ê Position the intrusion switch with the three wires on the front cover and

fasten it with two screws.

TX300 S3

Replacing the intrusion switches

Service Supplement