Fujitsu SPARC Enterprise T2000 Note sul prodotto - Pagina 19
Sfoglia online o scarica il pdf Note sul prodotto per Server Fujitsu SPARC Enterprise T2000. Fujitsu SPARC Enterprise T2000 28.
Anche per Fujitsu SPARC Enterprise T2000: Manuale introduttivo (2 pagine), Manuale introduttivo (12 pagine), Note sul prodotto (30 pagine)
Stampa la pagina
Specific Issues for the SPARC Enterprise T2000 Server (4 of 6)
TABLE 1
CR ID
Description
n/a
X-option and replacement hard drives might not
have an electronic disk label.
6508432 Many correctable errors (CE) could occur, and
although these errors are correctable, the system
could panic.
6538717 The showfru command reports Micron DIMMs as
Seagate DIMMs. For example:
[LE2]FRU_PROM at
MB/CMP0/CH0/R0/D0/SEEPROM
/SPD/Timestamp: MON APR 17 12:00:00 2006
/SPD/Description: DDR2 SDRAM, 1024 MB
/SPD/Manufacture Location:
/SPD/Vendor: Seagate <--should say Micron
6520334 If SSH is not enabled, executing the ssh-keygen -l
command to print keys generates the following error
message:
sc> ssh-keygen -l -t rsa
Fingerprint file cant be opened error
380003
This error message should read as follows:
ssh is not enabled.
6472072 When a panic dump is taken by Break-D of ALOM,
the panic message displays as follows:
Unrecoverable hardware error.
6500293,
After executing boot-r, the prtdiag-v command.
6502078
might not display host bus adaptors on SPARC
Enterprise T1000 or T2000 servers.
n/a
When the following devices are connected with ttya
(Dsub 9pin) on SPARC Enterprise T1000 or T2000
servers, you cannot install the Solaris OS.
• SH4124T (Dsub 9pin)
• Cisco Catalyst2960 (RJ45)
• SPARC Enterprise T2000 (Dsub 9pin)
Workaround
If you plan to replace or add a hard drive to
your server, the drive might not have an
electronic disk label and you must run the
Format utility to label the drive.
Add the following entry to /etc/system to
avoid the problem:
set pcie:pcie_aer_ce_mask = 0x2001
See
"Mandatory /etc/system File Entry" on
page
3.
Currently no workaround.
Enable SSH.
Hardware error does not occur. This message
can be safely ignored.
Reboot the system without reconfiguration.
Install Solaris OS with nothing connected with
ttya (Dsub 9pin).
Important Information About the SPARC Enterprise T2000 Server
11