Fujitsu FI-4120C2 - Document Scanner Come iniziare - Pagina 13
Sfoglia online o scarica il pdf Come iniziare per Scanner Fujitsu FI-4120C2 - Document Scanner. Fujitsu FI-4120C2 - Document Scanner 28. Image scanner
Anche per Fujitsu FI-4120C2 - Document Scanner: Manuale delle procedure di installazione (7 pagine), Manuale delle procedure di installazione (9 pagine), Opuscolo e specifiche (2 pagine)
Stampa la pagina
2. Connect the other end of the USB interface
cable to the PC.
•
Be sure to use the USB cable which
ATTENTION
comes as an accessory with this
scanner.
Correct operation with commercially
available cables is not guaranteed.
•
When connecting to an USB hub,
use the first stage USB hub that is
closest to the computer. If you use
the second or later hub stages, the
scanner may not operate correctly.
•
This scanner is provided with two
interfaces: Ultra SCSI and USB 2.0 /
1.1. On this scanner, each of the
SCSI and USB interface is con-
trolled not to be used simulta-
neously. Scanner can be only
connected to either USB or SCSI
interface.
■ Connecting the SCSI Interface Cable
When using the scanner with a SCSI interface, a com-
mercially available SCSI interface cable and SCSI card
must be purchased.
• SCSI interface cable:
Use a connector which complies with Ultra
SCSI. A 50 Pin Contact Shielded High-Density
SCSI Device Connector is used.
• SCSI card:
Find the recommended SCSI card information in
the Fujitsu web site (FAQ).
http://imagescanner.fujitsu.com/
•
When connecting the SCSI interface
ATTENTION
cable, turn the scanner off. Be sure
to first connect the SCSI interface
cable and, then turn on the power of
the scanner and the personal com-
puter.
•
In a SCSI daisy chain formation,
connect the scanner so that it is the
terminated device.
1. Insert the SCSI interface cable into the interface
connector until both sides click.
2. Connect the other end of the cable to the per-
sonal computer.
ATTENTION
HINT
ATTENTION
fi-4120C2 Image Scanner Getting Started
Be careful not to bend the pins of the
SCSI cable when connecting to the
scanner .
The factory default setting for SCSI ID
is "ID 5". If the SCSI ID of another SCSI
device is set to the same ID, either
change the scanner's SCSI ID or SCSI
ID of the other SCSI device. Set the
device address using the SCSI ID
switch on the back of the image scan-
ner.
5
Click
0
This scanner supports two interfaces:
Ultra SCSI and USB 2.0/1.1.
On this scanner, each of the SCSI and
USB interface can not to be used
simultaneously. Scanner can only
connect to the USB or SCSI interface.
4