Fujitsu FI-6130 Come iniziare - Pagina 19
Sfoglia online o scarica il pdf Come iniziare per Scanner Fujitsu FI-6130. Fujitsu FI-6130 23. Color duplex workgroup scanners
Anche per Fujitsu FI-6130: Manuale introduttivo (20 pagine), Opuscolo e specifiche (2 pagine), Manuale di istruzioni (10 pagine), Pulizia e manutenzione (47 pagine), Istruzioni per la pulizia (2 pagine)
Appendix1
■ Troubleshooting checklist
Symptom
Scanner does not turn on.
Scanning does not start.
fi-6140/fi-6240/fi-6130/fi-6230 Image Scanner Getting Started
TROUBLESHOOTING
Check this item
Have you pressed the power button on?
Are the AC cable and AC adapter
properly connected to the
scanner?
Is Windows normally started up?
Are the documents loaded correctly on the
ADF paper chute?
Is the ADF closed completely?
Is the USB cable or SCSI cable properly
connected?
(When using SCSI interface) Is SCSI ID
set correctly?
Does the Function Number Display
indicates an alarm or an error?
Does the alarm state remain displayed
even after the scanner has been turned off
and back on again?
Push the power button.
Correctly connect the AC cable and the AC adapter.
Disconnect the AC cable and the AC adapter from
the scanner, then connect them again.
If this does not restore the power supply, contact
the store where you purchased the scanner or an
authorized FUJITSU scanner service provider.
Push the power button again after completely
starting up Windows.
Load the document correctly on ADF paper chute.
Close the ADF completely.
Correctly connect the cable. (When a USB hub is
used, check the hub's power supply.)
Set SCSI ID correctly by SCSI ID switch on rear of
scanner.
When the Function Number Display indicates an
alarm or an error, refer to chapter 6 "Troubleshoot-
ing" of "fi-6140/fi-6240/fi-6130/fi-6230 Operator's
Guide" for removing the alarm or the error.
Turn off and on the power button.
If this does not eliminate the alarm state, contact the
store where you purchased the scanner or an
authorized FUJITSU scanner service provider.
AP-1
Remedy