Fujitsu M3093DE Procedure di installazione
Sfoglia online o scarica il pdf Procedure di installazione per Scanner Fujitsu M3093DE. Fujitsu M3093DE 3. Departmental duplex document scanner
Anche per Fujitsu M3093DE: Opuscolo (2 pagine), Opuscolo e specifiche (2 pagine), Manuale di istruzioni per la pulizia (12 pagine)
![Fujitsu M3093DE Procedure di installazione](/uploads/products/server2/2438241/2438241.png)
Fujitsu Video Scanner Installation Procedures
If you are installing the following models by means of the Video interface then use this
document.
M3093E
M3093EX
M3093DE
Hardware requirements.
You will need a PC system that meets our recommended specifications, an appropriate video
controller (Kofax 850/1700V series), and a "Y" cable. For recommended PC system
specifications and Video controllers please reference the
You may also need your Operating System Disk.
Step A: Installing the Serial-Video driver.
1. First boot your PC and install the driver that shipped with the controller card or
download the driver from the controller manufacturer's Web page. Special note: If
you are installing a Kofax driver and any other software that contains Kofax's Image
Controls pay close attention to the individual runtimes. It is strongly recommended
that you install the oldest/lower runtime first.
Step B: Installing the Serial-Video controller.
2. Shut down your PC and remove the case cover.
3. Locate a free PCI slot and remove the back plate if necessary.
4. Install the SCSI controller in an open PCI slot. Make sure that the card is seated
completely in the slot and secured in the frame.
Warning! Failure to secure the controller in the PC can result in damage to the
controller, scanner, and/or your system.
5. Boot your PC without the scanner attached and check for errors. If no errors then
proceed to the next step.
Step C: Unlocking the shipping lock.
If your model scanner does not have a flatbed then proceed to Step F.
The flatbed model scanners typically include a lock on the flatbed designed to protect
the scanner during shipment. Before the scanner can be used the shipping lock must be
unlocked. To unlock it do the following:
1. Located the shipping lock slider tab or knob underneath the end of the scanner.
2. Slide or rotate the lock to the unlock position.
Rev051806A
Windows 98SE\ME\2000\XP
M3096E
M3096EX
M3097E+
M3097DE
M3099A
M3099EX
Scanner Hardware Reference
M3099EH
M4097D
M4099D
page.
Page 1 of 3