Fujitsu M4099D Procedure di installazione

Sfoglia online o scarica il pdf Procedure di installazione per Scanner Fujitsu M4099D. Fujitsu M4099D 3. A3 duplex document scanner
Anche per Fujitsu M4099D: Manuale delle procedure di installazione (7 pagine), Manuale delle procedure di installazione (9 pagine), Opuscolo (2 pagine), Procedure di installazione (3 pagine), Procedure di installazione (3 pagine), Opuscolo e specifiche (2 pagine), Opuscolo e specifiche (2 pagine), Scheda tecnica (2 pagine), Istruzioni per la pulizia (2 pagine)

Fujitsu SCSI

Scanner Installation Procedures with

If you are installing the following model scanners with the Kofax 850S or 1700S

Adrenaline SCSI controller and a GSA-1 scanner interface card then use this document.

M4097D-VRS

Hardware requirements.

1. You will need a PC system that meets both Fujitsu's and Kofax's

recommended specifications

2. Kofax 850S/1700S Adrenaline controller for the M4097D/M4099D respectively.

3. Six foot (maximum) Wide SCSI 68-pin to 68-pin cable.

For recommended PC system specifications and SCSI controllers please

reference the

Scanner Hardware Reference

Operating System Disk.

Step A: Installing the VRS drivers.

First boot your PC and install the Kofax VRS drivers that shipped with the scanner.

The installation includes the adrenaline hardware runtime drivers. The drivers can be

down loaded from the following link

Special note: When installing the VRS drivers and any other software that contains

Kofax's Image Controls pay close attention to the individual runtimes. It is strongly

recommended that you install the oldest/lower runtime application first.

Step B: Installing the Adrenaline 850S/1700S Adrenaline controller

1. Shut down your PC and remove the case cover.

2. Locate a free PCI slot and remove the back plate if necessary.

3. Install the SCSI controller in an open PCI slot. Make sure that the card is

seated completely in the slot and secured in the frame.

Warning! Failure to secure the SCSI controller in the PC can result in damage

to the SCSI card, scanner, and/or your system.

4. Boot your PC without the scanner attached and check for errors.

Step C: Unlocking the shipping lock.

If your model scanner does not have a flatbed then proceed to Step D.

The flatbed model scanners typically include a lock on the flatbed designed to

protect the scanner during shipment. Before the scanner can be used the

shipping lock must be unlocked. To unlock it do the following:

Rev010807L

Windows 2000 / XP

M4099D-VRS

Drivers and

VRS (GSA-1)

page. You may also need your

Downloads.

Page 1 of 3