Fujitsu ETERNUS DX Disk Manuale di configurazione - Pagina 6

Sfoglia online o scarica il pdf Manuale di configurazione per Immagazzinamento Fujitsu ETERNUS DX Disk. Fujitsu ETERNUS DX Disk 21. Server connection, fcoe for linux driver settings for converged network adapter cards
Anche per Fujitsu ETERNUS DX Disk: Manuale d'uso (35 pagine), Manuale d'uso (42 pagine), Manuale di configurazione (28 pagine), Manuale di configurazione (44 pagine), Manuale di configurazione (28 pagine), Manuale di configurazione (29 pagine), Manuale di configurazione (25 pagine), Manuale di configurazione (32 pagine), Manuale di configurazione (35 pagine), Manuale di configurazione (31 pagine), Manuale di configurazione (43 pagine), Manuale di configurazione (24 pagine)

Chapter 1

Setup Procedure for Emulex Converged Network Adapter Cards

1.2

Setting Up the Converged Network Adapter Cards

Creating an Initial RAM Disk

Create an initial RAM disk to match the kernel being used.

"1.5 Creating an Initial RAM Disk" (page 10)

•

Now proceed to the next workflow described in "Connecting the Server to the ETERNUS DX storage sys-

tems" of the "Configuration Guide -Server Connection- (FCoE) for Linux".

1.2

Setting Up the Converged Network Adapter Cards

Install the Converged Network Adapter card to the server, and acquire the physical address and World Wide

Name (WWN) for the Converged Network Adapter card.

•

The physical address and WWN of a Converged Network Adapter card are required information in the fol-

lowing cases: when an error has occurred in the system, when using the ETERNUS DX storage systems (se-

curity function, host affinity function, etc.) to restrict server access, or when connecting the ETERNUS DX

storage systems and the server using a Fibre Channel switch and a CEE/FCoE switch.

Acquire the physical address and WWN when installing the Converged Network Adapter card, because the

•

relationship between a physical address and WWN cannot be determined from BIOS and OS. Physical ad-

dress and WWN must be assigned to "WWN instance management table for the server".

The workflow is shown below.

(1) Install the Converged Network Adapter card

(2) Turn on the server

(3) Acquire the physical address and WWN for the Converged Network Adapter card

(4) Add a record for the server in the WWN instance management table for the server

When installing two or more Converged Network Adapter cards in the server, first turn off the server, then

repeat Steps (1) through (4) above for each Converged Network Adapter card to be installed.

The procedure is as follows:

Install the Converged Network Adapter card in the server.

For the installation method, slot positions, activation of the installed slot, and notes regarding the Con-

verged Network Adapter card, refer to the Converged Network Adapter card documentation or the User's

Guide of the server.

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for Linux

P3AM-6402-11ENZ0