Fujitsu ETERNUS2000 200 Manuale di connessione al server - Pagina 17

Sfoglia online o scarica il pdf Manuale di connessione al server per Immagazzinamento Fujitsu ETERNUS2000 200. Fujitsu ETERNUS2000 200 25. Disk storage systems (fibre channel) for oracle solaris
Anche per Fujitsu ETERNUS2000 200: Manuale (28 pagine), Manuale (21 pagine), Manuale di connessione al server (32 pagine), Manuale di configurazione (4 pagine), Manuale di connessione (19 pagine), Utilizzo di prodotti opzionali (2 pagine)

Chapter 8

Connect the ETERNUS Disk storage system to the server with a LAN cable.

After connecting, reboot the Linux server and check that the Linux server recognizes the

ETERNUS Disk storage system LUNs.

YaST is used to set up the server. Refer to the Novell web-site for details of the setup procedure

with YaST.

8.1

P3AM-4152-02ENZ0

ETERNUS Disk storage systems Server Connection Guide (iSCSI) for Linux

(SUSE Linux Enterprise Server)

ETERNUS Disk Storage System Logical

Unit Recognition

Procedure

Start YaST and then run the iSCSI Initiator in Miscellaneous.

Select the "Discovered Targets" tab and click the [Discovery] button to open the

iSCSI Initiator Discovery dialog.

Set the IP address for the ETERNUS Disk storage system iSCSI port in "IP

Address".

Keep the default port number value (3260).

Check that "No_Authentification" is selected and click the [Next] button.

Check that the desired Target is visible in the "Discovered Targets" tab.

The "Connected" state of the Target should be "False" at this time.

Select the desired Target in the "Discovered Targets" tab, and click the [Log In]

button to re-open the CHAP selection dialog.

If CHAP authentication is not being used, check that "No_Authentification" is selected and

click the [Next] button.

After both path logins have completed, check that the information of the desired

Target is visible in the "Connected Targets" of the iSCSI Initiator Overview.

Make sure that "Start-Up" for the desired Target is set to "automatic" (if currently

set to "manual", select the Target and click the [Toggle Start_Up] button), then

click the [Finish] button.

End of procedure