AEG OKO-LAVAMAT BELLA2100 Libretto di istruzioni - Pagina 41

Sfoglia online o scarica il pdf Libretto di istruzioni per Lavatrice AEG OKO-LAVAMAT BELLA2100. AEG OKO-LAVAMAT BELLA2100 45. Aeg the environmentally friendly washing machine

Stampa la pagina

The inlet hose must not be lengthened. If it is too short and you do not

wish to move the tap, you will have to purchase a new, longer hose spe-

cially designed for this type of use.

Water drainage

The end of the drain hose can be positioned

in three ways:

Hooked over the edge of a sink using the

plastic hose guide supplied with the

machine. In this case, make sure the end

cannot come unhooked when the machine

is emptying.

This could be done by tying it to the tap

with a piece of string or attaching it to the

wall.

In a sink drain pipe branch. This branch must be above the trap so that

the bend is at least 60 cm above the ground.

Directly into a

drain pipe at a

height of not less

than 60 cm and

not more than

90 cm.

The end of the

drain hose must always be ventilated, i.e. the inside diameter of the

drain pipe must be larger than the outside diameter of the drain hose.

The drain hose must not be kinked. Run it along the floor; only the part

near the drainage point must be raised.

Electrical connection

This machine is designed to operate on a 220-230 V, single-phase,

50 Hz supply.

Check that your domestic electrical installation can take the maximum

load required (2.2 kW), also taking into account any other appliances in

use.

Connect the machine to an earthed socket.

The manufacturer does not accept any responsibility for damage or

injury through failure to comply with the above safety precaution.

Installation