Brother CP-2000 Manuale d'uso - Pagina 17

Sfoglia online o scarica il pdf Manuale d'uso per Software Brother CP-2000. Brother CP-2000 33. Copyboard
Anche per Brother CP-2000: Manuale d'uso (19 pagine), Opuscolo e specifiche (4 pagine), Elenco di riferimento delle parti (18 pagine)

While holding both sides of the copyboard, hook the brackets at the back

of the copyboard onto the wall-mounting bar pegs.

Do not release the copyboard

until you are sure that it is

securely mounted on the wall-

mounting bar.

Do not push the unit upward

or to either side, otherwise it

may fall down.

Attach the tray by sliding its slots over the two brackets on the front of the

copyboard above the printer.

Do not subject the tray to strong impacts or use it in any way other than for

holding markers and erasers.

Re-attaching the stand

Lay the copyboard on the floor facing downward with the printer

control panel and writing surface positioned over a piece of cloth or

other protective sheet to prevent them from being damaged.

Use the six screws (three on each side) to attach the stand to the back

of the copyboard by tightening the screws in order according to the

numbering on each bracket of the stand (1, 2, then 3).

While the stand is being used, it is recommended that the wall-mounting

brackets be removed in order to avoid that they be pulled on with excessive

force. After removing the wall-mounting brackets, re-attach the plates. Refer

to step

of Mounting the copyboard on page 11.

2. Setup