AEG ARCTIS Manuale di istruzioni per l'uso - Pagina 11

The freezer needs ventilation

Air is fed under the door through the vent

slots in the base and is exhausted upwards

along the back wall. To ensure proper air cir-

culation never cover or alter the vent ope-

nings.

Attention! If the appliance is installed under,

for example, a hanging cabinet, a clearance of

at least 10 cm between the top of the

appliance and the cabinet above it must be

maintained.

1. Break both wall spacing ele-

ments from the plinth and insert

them into the sockets at the

back side of the appliance,

according to the figure, so that

the required wall gap for the

necessary ventilation at the back

of the appliance is provided for.

A properly installed socket outlet with earthing contact is required for

electrical connection. Electrical fuse protection must be of at least 10

ampere.

If the outlet socket is no longer accessible after installation of the

appliance, appropriate measures must be taken during electrical instal-

lation to assure that the appliance can be disconnected from the mains

(e.g. fuse, circuit breaker, non-operate current safety-switch or the like,

with a contact opening of at least 3 mm).

1. Before initial start-up, refer to the appliance rating plate to ascertain if

supply voltage and current values correspond with those of the mains

at the installation location.

e. g.: AC 220 ... 240 V 50 Hz or

220 ... 240 V~ 50 Hz

(i.e. 220 to 240 volts alternating current, 50 Hertz)

The rating plate is inside the appliance at the left.

Installation