AEG RCB53724MW Manuale d'uso - Pagina 10

Sfoglia online o scarica il pdf Manuale d'uso per Frigorifero AEG RCB53724MW. AEG RCB53724MW 16.
Anche per AEG RCB53724MW: Manuale d'uso (16 pagine), Manuale d'uso (16 pagine)

Stampa la pagina

www.aeg.com

Problem

The compressor does not

start immediately after

pressing the FROSTMATIC

or after changing the tem-

perature.

Water flows inside the re-

frigerator.

Water flows on the floor.

Temperature cannot be set. The FROSTMATIC or

The temperature in the ap-

pliance is too low/too high.

Side panels of the appli-

ance are warm.

Possible cause

The room temperature is

too high.

Food products placed in

the appliance were too

warm.

The FROSTMATIC function

is switched on.

This is normal, no error has

occurred.

The water outlet is clog-

ged.

Food products prevent wa-

ter from flowing into the

water collector.

The melting water outlet is

not connected to the evap-

orative tray above the com-

pressor.

COOLMATIC function is

switched on.

The temperature regulator

is not set correctly.

The food products temper-

ature is too high.

Many food products were

stored at the same time.

The FROSTMATIC function

is switched on.

This is a normal state

caused by operation of the

heat exchanger.

Solution

Refer to climate class chart on

the rating plate.

Allow food products to cool to

room temperature before stor-

ing.

Refer to "FROSTMATIC func-

tion".

The compressor starts after

some time.

Clean the water outlet.

Make sure that food products

do not touch the rear plate.

Attach the melting water out-

let to the evaporative tray.

Switch off FROSTMATIC or

COOLMATIC manually, or wait

until the function resets auto-

matically to set the tempera-

ture. Refer to "FROSTMATIC

or COOLMATIC function".

Set a higher/lower tempera-

ture.

Let the food products temper-

ature decrease to room tem-

perature before storage.

Store less food products at the

same time.

Refer to "FROSTMATIC func-

tion".