Fujitsu FTP-639MCL354 Specifiche del prodotto - Pagina 6

Sfoglia online o scarica il pdf Specifiche del prodotto per Stampante Fujitsu FTP-639MCL354. Fujitsu FTP-639MCL354 26.

Stampa la pagina

(3)

When plugging in and out FPC to the connector of the control side, be sure that all power is

turned off before doing that.

(4)

Use our recommended connector as the one of the control side of FPC. If any other

connector is used, fully confirm the properties (the contact resistance, drawing strength, and

the allowable power supply voltage) before using.

(5)

The back tension of the rolled paper should be equal or less than 1.96N (200g) including the

start up. If it exceeds equal or greater than 1.96N, the platen gear may get off the track and

causes to damage the gear.

(6)

For the attitude of mounting the cutter, follow the instructions below.

Attitude C: Do not use C because pape r chips intrude the cutter.

2-3

Paper to be used

（ 1 ）

Regarding the printing quality and lifetime; therefore, carefully confirm the property of the

paper before using.

（ 2 ）

When using the perforated paper, the punching direction of the perforations should be set to

face the thermosensitive side. The height of burrs of the perforations and dusts of them may

cause troubles such as deterioration of the printing quality, the paper end sensor, the platen

gear 's getting off the track, and the lifetime; therefore, carefully check the perforated paper

before using.

（ 3 ）

To reduce the loads during the paper feeding and to improve the sensitivity of the paper end

sensor, when rolling the paper, the thermosensitive side of the paper should be faced outside.

（ 4 ）

Use the rolled paper of which inner diameter should be equal or greater than φ 8 (the

diameter when there is not core).

2-4 Cleaning

Paper residues or foreign matter may shorten the life of the head or platen. Clean the

printer periodically.

2-5

Storing

（ 1 ）

When storing the printer for the long-term (equal or longer than six months at the room

temperature), lift down the platen-release lever and insert the paper between the head and the

platen. If the rubber part of the platen and the head have continued to directly contact for a

long term, the rubber part will be deformed and may affect the quality of printing.

（ 2 ）

Do not store the printer in damp places and places with drastic temperature variations.

Condensation on the printer may cause troubles such as thermal head damages and action

failures.

（ 3 ）

Do not store the printer in dusty places. Using the printer with dusts adhered on it may

cause troubles to the printing and actions.

Date

Design

Inspection

Rev.

Design

Changes made

Inspect.

FTP-639MCL354 SPECIFICATION

A1NA02273-0354

FUJITSU COMPONENT LIMITED

Approv.

Submit to