Fujitsu Cider Q550 Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Tavoletta Fujitsu Cider Q550. Fujitsu Cider Q550 33.

Stampa la pagina

NEW ZEALAND WARNINGS

The grant of a Telepermit for any item of terminal

equipment indicates only that Telecom has

accepted that the item complies with minimum

conditions for connection to its network. It

indicates no endorsement of the product by

Telecom, nor does it provide any sort of warranty.

Above all, it provides no assurance that any

item will work correctly in all respects with

another item of Telepermitted equipment of a

different make or model, nor does it imply that

any product is compatible with all of Telecom's

network services.

This equipment is not capable under all operating

conditions of correct operation at the higher

speeds for which it is designed. 56 KBPS

connections are likely to be restricted to

lower bit rates when connected to some

PSTN implementations. Telecom will accept no

responsibility should difﬁ culties arise in such

circumstances.

Immediately disconnect this equipment should it

become physically damaged, and arrange for its

disposal or repair.

This equipment shall not be used in any manner,

which could constitute a nuisance to other

Telecom customers.

This equipment shall not be set to make

automatic calls to the Telecom "111" Emergency

Service.

This device is equipped with pulse dialing while

the New Zealand standard is DTMF tone dialing.

There is no guarantee that Telecom lines will

always continue to support pulse dialing. It is

strongly recommended that pulse dialing is not

used.

Some parameters required for compliance

with Telecom's Telepermit requirements are

dependent on the equipment (PC) associated

with this device. The associated equipment shall

be set to operate within the following limits for

compliance with Telecom's Speciﬁ cations:

For repeat calls to the same number.

There shall be no more than 10 call attempts

to the same number within any 30 minute

period for any single manual call initiation and

the equipment shall go on-hook for a period

of not less than 30 seconds between the end

of one attempt and the beginning of the next

attempt.

For Automatic calls to different numbers.

The equipment shall go on-hook for a period

of not less than 5 seconds between the end

of one attempt and the beginning of the next

attempt.

For Automatically answered Incoming

Calls.

Incoming calls shall be answered between 3

and 30 seconds from the start of the ringing.

For correct operation, the total of the RNs of all

devices connected to a single line at anytime

should not exceed 5. The RN of this Equipment

is 0.5.

WARNING:

C O N N E C T I O N O F N O N C E RT I F I E D /

APPROVED PERIPHERALS MAY RESULT IN

THE EQUIPMENT OPERATING OUTSIDE THE

NEW ZEALAND EMI STANDARDS.