Fujitsu P-600 - Stylistic LT Istruzioni per l'installazione

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Tavoletta Fujitsu P-600 - Stylistic LT. Fujitsu P-600 - Stylistic LT 1. Pen tablet holster
Anche per Fujitsu P-600 - Stylistic LT: Manuale di installazione (4 pagine), Manuale d'uso (8 pagine), Manuale d'uso (2 pagine), Istruzioni (4 pagine), Manuale di installazione (4 pagine), Manuale d'uso (4 pagine)

FMW43SA01

Serial Adapter (DB9)

Installation Instructions

Stylistic LT Series

The Serial Adapter allows you to connect a serial device

directly to your pen tablet without a docking device. The

port is a fully functional RS-232-C serial port that can be

used as a standard serial port on your pen tablet.

On one side of the adapter is a plug which fits into the

system interface port (see Figure 1). On the opposite side

of the adapter is a 9-pin port for a serial connector (see

Figure 2).

To install the adapter,

1. If the pen tablet is running, either suspend

operation or power down the system.

2. If the serial device you wish to connect has power

applied, remove power.

3. Remove the plastic cover that is located over the

system interface port on the bottom edge of the

pen tablet. Keep the cover in a safe place for future

reinstallation.

4. Plug the Serial Adapter into the system interface

port. The plug is keyed so that it will only fit when

it is positioned properly (see Figure 3).

5. Insert the serial plug into the serial connector (see

Figure 2).

6. Restart the system and the serial device.

To remove the adapter,

1. If the pen tablet is running, either suspend

operation or power down the system.

2. If the serial device you wish to disconnect has

power applied, remove power.

3. Pull the plug from the connector. Replace the

plastic cover over the interface port.

4. Restart your system.

8/00

Note: When the Serial Adapter is attached to the pen

tablet, the tablet cannot be used in the compact desk

stand because the connector/cable assembly extends

too far from the bottom of the system. The system

should be held or laid flat when the Serial Adapter is

installed.

Figure 1. System Interface Connector Side

Figure 2. Serial Connector Side

Figure 3. Installing the Serial Adapter

58-0765-00A