Fujitsu SK-8FX-TSC-32PMC Manuale d'uso - Pagina 16
Sfoglia online o scarica il pdf Manuale d'uso per Scheda madre Fujitsu SK-8FX-TSC-32PMC. Fujitsu SK-8FX-TSC-32PMC 28.
3 Jumpers and Switches
This chapter describes all jumpers and switches that can be modified on the evaluation
board. The default setting is shown with a grey shaded area.
3.1 Power Supply (JP3)
The SK-8FX-TSC-32PMC is by default powered by the USB connection to a host PC or USB
power supply. Alternatively, a stabilized supply voltage can be connected to the pin headers
X4 (GND) and X5 (VCC). JP3 must be opened in this case to disconnect the voltage
supplied by the USB connector X3.
JP3:
Connects VCC to USB power supply
Jumper
JP3
(USBPWR)
3.2 User LEDs (JP1)
Eight LEDs are supplied for user applications. In order to disable the LEDs e.g. to use the
related microcontroller port (Port P62-P67, P06-P07) for other connections, JP1 (solder
jumper) can be opened.
JP1:
Enables User LEDs LD2-LD9 to VCC
Jumper
JP1
(LED_VCC)
The User LEDs are connected to the MCU pins according to the table below:
FMEMCU-UG-90003-10
SK-8FX-TSC-32PMC User Guide
Chapter 3 Jumpers and Switches
Setting
Description
Closed
Board powered by USB (X3)
Open
Board not powered by USB
Table 3-1: Power Supply Configuration
Setting
Description
Closed
LEDs enabled (anodes connected to VCC)
Open
LEDs disabled
Table 3-2: Use LED enable / disable
LED Number
MCU Pin
LD2
LD3
LD4
LD5
LD6
LD7
LD8
LD9
Table 3-3: User LED connections
- 16 -
MCU Port
10
P62
9
P63
8
P64
7
P65
6
P66
5
P67
19
P06
20
P07
© Fujitsu Semiconductor Europe GmbH