Fujitsu SK-91460T-144PMC-GPIO Manuale d'uso - Pagina 36

Sfoglia online o scarica il pdf Manuale d'uso per Scheda madre Fujitsu SK-91460T-144PMC-GPIO. Fujitsu SK-91460T-144PMC-GPIO 47. Mb91460 series

2) If the programming software should generate a reset signal on RTS or DTR line, refer

to the following jumper list.

Jumper

JP20

(RTS-CTS)

JP89

(DTR/RTS)

JP16

(RST 0/4)

JP13

(DTR / DTRx)

JP38

(RST MCU)

3) The CPU Mode selection must be set to internal reset vector mode by setting DIP

switch S1 to (Off, Off, Off, Off) (only if DIP Switch mounted!)

4) Start the 'FME-FR Programmer' and connect the UART4 to your serial PC

communication port. A straight cable connection has to be used.

5) Choose the microcontroller device ("MB91F467T") as device type and browse to the

mhx-file you want to program to the embedded flash memory of the microcontroller.

Press the button "Automatic Mode" to start programming.

6) After that, immediately reset the microcontroller.

FMEMCU-UG-910074-11

SK-91460T-144PMC-GPIO User Guide

Chapter 6 Programming the internal Flash

Setting

Description

Closed

RTS and CTS of X2 are connected

Open

RTS and CTS of X2 are not connected

1-2

DTR signal (Pin 6 of X2) is used as reset source

2-3

RTS signal (Pin 7 of X2) is used as reset source

Closed

LIN-UART 4 (X2) connected to reset circuit

1-2

No negation for the DTR/RTS signal

2-3

DTR/RTS signal is negated

Closed

External reset generation is active

Table 6-2: Jumper Settings for reset signal

- 36 -