Fujitsu SK-91460T-144PMC-GPIO Manuale d'uso - Pagina 39
Sfoglia online o scarica il pdf Manuale d'uso per Scheda madre Fujitsu SK-91460T-144PMC-GPIO. Fujitsu SK-91460T-144PMC-GPIO 47. Mb91460 series
Stampa la pagina
7 Troubleshooting
Problem
Starter-kit does not power-on correctly.
Some or all of the power LEDs (D20 and
D28) do not light.
Starter-kit stays in reset.
LED D10 (Reset indicator) lights up
permanently.
The
communication
Workbench to the evaluation board fails
(Communication errors).
The windows of the debugger are empty.
When trying to program the application to
the embedded flash, the programmer
stops at first address with "loading error" !
Hardware units such as LEDs, user
buttons, UART are not working.
Optional LC-Display at J1 does not work
Graphic sub-board does not work
© Fujitsu Microelectronics Europe GmbH
SK-91460T-144PMC-GPIO User Guide
Chapter 7 Troubleshooting
Solution
Check voltage supply and jumpers :
∗ The voltage on DC-Power plug should be in the
range of 9-12V. The plug should have '+' on shield
and '–' on the centre. The power supply should be
able to supply at least 500 mA. To support both,
the "SK-91F460T-144PMC-GPIO" and a graphic
sub-board the supply should be able to supply
1500mA.
* The LEDs should light up after switching on the
board. Use a millimetre to see whether 5V,3.3V,
are present on the Vcc/GND test measurement
points J9, J10.
∗ Check jumper positions according to chapter 2.2.
∗ Remove all user extensions of the starter-kit
∗ LED D10 (Reset) should flash. If D10 lights up
permanently, the voltage is too low. Increase the
voltage supply and check available supply current
to solve the problem.
∗ Remove all user extensions on the board to avoid
any shortcuts or leakage current!
∗ Make sure your COM-port number and the baud
from
Softune
rate
introduction). The default COM-port is 1 and the
default baud rate is 57.6 kBaud.
∗ Make sure no other programs are using the same
COM-port on your PC. Close all other applications
(e.g. flash programmer utilities, terminals etc.)
* Check if RTS/CTS is closed on the CPU module
(check jumper JP21, 25, 20 are closed).
* Use only a RS232 extension 1:1 cable.
* This is due to wrong (maybe old) file path
information. Closing all windows in the debugger
and re-open should fix the problem.
* You are probably trying to program a program to
the flash which is linked for the external RAM area.
Check for details the linker memory map and the
linker output mapping file *.mp1 file.
∗ Make sure you have enabled these units on the
evaluation board using the appropriate jumpers.
See the provided examples and the hardware
manual for information on how to control the
peripherals.
∗ Adjust the potentiometer RP1 to adjust contrast
of LCD. Remove resistor network RN1.
Check power supply 9-12V/1500mA. Reduce
external bus clock frequency.
- 39 -
settings
are
correct
FMEMCU-UG-910074-11
(see
debugger