Indesit BAN 40 FNF SWD Manuale di istruzioni per l'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Frigorifero Indesit BAN 40 FNF SWD. Indesit BAN 40 FNF SWD 12. Refrigerator/freezer combination

Indesit BAN 40 FNF SWD Manuale di istruzioni per l'uso

Maintenance and care

GB
Switching the appliance off
During cleaning and maintenance it is necessary to disconnect the
appliance from the electricity supply:
1. set the FREEZER OPERATION knob on
2. pull the plug out of the socket
Cleaning the appliance
• The external and internal parts, as well as the rubber seals may
be cleaned using a sponge that has been soaked in lukewarm
water and bicarbonate of soda or neutral soap. Do not use
solvents, abrasive products, bleach or ammonia.
• The removable accessories may be soaked in warm water and
soap or dishwashing liquid. Rinse and dry them carefully.
• The back of the appliance may collect dust which can be
removed by delicately using the hose of a vacuum cleaner set
on medium power. The appliance must be switched off and the
plug must be pulled out before cleaning the appliance.
Avoiding mould and unpleasant odours
• The appliance is manufactured with hygienic materials which are
odour free. In order to maintain an odour free refrigerator and to
prevent the formation of stains, food must always be covered or
sealed properly.
• If you want to switch the appliance off for an extended period of
time, clean the inside and leave the doors open.
Holiday function
If you are going on holiday, you do not have to switch the appliance
off; it features a low-energy function which optimises the
temperature of the refrigerator compartment to suit the products
stored inside it (you may, for example, wish to protect cosmetics
and beauty products from the heat). The freezer temperature must
be set to the minimum value in order to preserve the food.
To enable the function: set the REFRIGERATOR OPERATION knob
on HOLIDAY ( see diagram ).
A double acoustic signal informs you when it has been enabled. A
single acoustic signal informs you when it has been disabled.
Replacing the l Odour filter
The filter should be replaced after approximately 6-8 months from
when it is activated. This period may vary depending on the type of
food that is stored. For information on where a replacement filter may
be purchased, contact Assistance ( see Assistance ).
To replace the filter, follow the instructions ( see diagrams A and B ).
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR 5 YEAR PARTS GUARANTEE ON 08448 24 24 24
8
Replacing the light bulb
To replace the light bulb in the refrigerator compartment, pull out
the plug from the electrical socket. Follow the instructions below.
Access the light bulb by removing the cover as indicated in the
diagram. Replace it with a similar light bulb within the power range
indicated on the cover (10W).
2
1

Precautions and tips

! The appliance was designed and manufactured in compliance
with international safety standards. The following warnings are
provided for safety reasons and must be read carefully.
This appliance complies with the following Community Directives:
- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent
amendments;
-89/336/EEC of 03.05.89 (Electromagnetic Compatibility) and
subsequent amendments;
- 2002/96/CE.
General safety
• The appliance was designed for domestic use inside the home
and is not intended for commercial or industrial use.
• The appliance must be used to store and freeze food products
by adults only and according to the instructions in this manual.
• The appliance must not be installed outdoors, even in covered
areas. It is extremely dangerous to leave the appliance exposed
to rain and storms.
• Do not touch the appliance with bare feet or with wet or moist
hands and feet.
• Do not touch the internal cooling elements: this could cause skin
abrasions or frost/freezer burns.
• When unplugging the appliance always pull the plug from the
mains socket, do not pull on the cable.
• Before cleaning and maintenance, always switch off the
appliance and disconnect it from the electrical supply. It is not
sufficient to set the temperature adjustment knobs on
(appliance off) to eliminate all electrical contact.